The protests against the nuclear power plant at Kudankulam have intensified over the recent weeks.  The Kudankulam plant is expected to provide 2 GW of electricity annually.  However, activists concerned about the risks of nuclear energy are demanding that the plant be shut down.  The safety of nuclear power plants is a technical matter.  In this blog post we discuss the present mechanism to regulate nuclear energy and the legislative proposals to amend this mechanism. Atomic materials and atomic energy are governed by the Atomic Energy Act, 1962.  The Act empowers the central government to produce, develop and use atomic energy.  At present, nuclear safety is regulated by the Atomic Energy Regulatory Board (AERB).  Some of the drawbacks of the present mechanism are discussed below. Key issues under the present nuclear safety regulatory mechanism The AERB is not empowered to operate as an independent operator.  The AERB was established by the government through a notification and not through an Act of Parliament.  Its powers and functions are therefore amendable by the Department of Atomic Energy through executive orders.  The parliamentary oversight exercised upon such executive action is lower than the parliamentary oversight over statutes. [1. The executive action or the Rules are in force from the date of their notification.  They are to be tabled before Parliament mandatorily.  However, an executive action is discussed and put to vote in Parliament only if an objection is raised by a Member of Parliament.  The executive orders may be reviewed by the committee on sub-ordinate legislation.  However, this committee has to oversee a large volume of rules and regulations.  For instance, there were 1264 statutory notifications that were tabled before the Rajya Sabha in 2011-12.] Furthermore, the Atomic Energy Commission that sets out the atomic energy policy, and oversees the functioning of the AERB, is headed by the Secretary, Department of Atomic Energy.  This raises a conflict of interest, as the Department exercises administrative control over NPCIL that operates nuclear power plants. It is pertinent to note that various committee reports, including a CAG Report in 2011, had highlighted the drawbacks in the present regulatory mechanisms and recommended the establishment of a statutory regulator.  A summary of the Report may be accessed here. Proposed mechanism Following the Fukushima nuclear incident in 2011, the Nuclear Safety Regulatory Authority Bill, 2011 was introduced in Parliament to replace the AERB. The Bill establishes the Nuclear Safety Regulatory Authority (NSRA) to regulate nuclear safety, and a Nuclear Safety Council to oversee nuclear safety policies that the NSRA issues.  Under the Bill, all activities related to nuclear power and nuclear materials may only be carried out under a licence issued by the NSRA. Extent of powers and independence of the NSRA The Bill establishes the NSRA as a statutory authority that is empowered to issue nuclear safety policies and regulations.  The Nuclear Safety Council established under the Bill to oversee these policies includes the Secretary, Department of Atomic Energy.  The conflict of interest that exists under the present mechanism may thus continue under the proposed regulatory system. The Bill provides that members of the NSRA can be removed by an order of the central government without a judicial inquiry.  This may affect the independence of the members of the NSRA.  This process is at variance with enactments that establish other regulatory authorities such as TRAI and the Competition Commission of India.  These enactments require a judicial inquiry prior to the removal of a member if it is alleged that he has acquired interest that is prejudicial to the functions of the authority. The proposed legislation also empowers the government to exclude strategic facilities from the ambit of the NSRA.  The government can decide whether these facilities should be brought under the jurisdiction of another regulatory authority. These and other issues arising from the Bill are discussed here.


The Monetary Policy Committee (MPC) has decided to conduct an off-cycle meeting today to discuss the failure to meet the inflation target under Section 45ZN of the Reserve Bank of India Act, 1934. As per the Reserve Bank of India Act (RBI), 1934, MPC is required to meet at least four times each year, to discuss the macroeconomic issues in the country, and take policy decisions to address those. This is the second time MPC has conducted an off-cycle meeting in 2022-23. The meeting is scheduled in light of inflation being consistently high for nine consecutive months.

In this blog, we discuss what the inflation targeting framework is, examine retail and wholesale prices, and the divergence between them.   

What is the inflation targeting framework, and what happens if inflation is persistently high?

In 2016, Parliament amended the RBI Act, 1934 to change the monetary policy, and introduce an inflation targeting framework. This framework prioritises price stability to achieve sustainable GDP growth. Price stability allows investors to confidently invest their money for productive activities, without worrying about it losing value. Price stability also maintains the purchasing power of consumers, i.e., the ability to purchase a good (or service) with a given amount of money.

As per the new framework, the central government, in consultation with RBI sets: (i) an inflation target, and (ii) an upper and lower tolerance level for retail inflation. The target has been set at 4%, with an upper tolerance limit of 6% and a lower tolerance limit of 2%. The upper and lower limits indicate that although it is desirable for inflation to be close to 4%, deviation between these limits is acceptable. The target and bands are revised every five years. In March 2021, the existing targets were carried forward.  

Retail inflation has been above 6% for the past nine months, and it has been above 4% from October 2019 onwards (See Figure 1).

Figure 1: Consumer price index (year-on-year; in percentage)

image

Sources: Database on Indian Economy, Reserve Bank of India; PRS.

If inflation is above or below the prescribed limits for three quarters, RBI must submit a report to the central government explaining why prices have been rising (or falling) persistently, what will be done to correct that, and an estimate as to when the target will be achieved.   

The MPC uses tools such as interest rates to control the level of inflation in the economy. One such rate is the policy repo rate, which is the rate at which RBI lends money to banks. An increase in the policy repo rate makes borrowing money more costly, and hence is expected to control inflation by reducing the money supply. MPC increased this rate from 4% in April 2022 to 4.4% in May 2022, to 4.9% in June 2022, to 5.4% in August 2022, and to 5.9% in September 2022.

Breaking down the Consumer Price Index and the Wholesale Price Index

Consumer Price Index (CPI) measures the general prices of goods and services such as food, clothing, and fuel over time. Retail inflation is calculated as the change in the CPI over a period of time. Goods and services such as petrol, food products, health, and education are considered for its calculation, which are assigned different weights (See Table 1). Between February 2022 and August 2022, the average annual inflation was 6.9%. The rise in prices of subcomponents of the CPI during this period is indicated in Table 2.

Table 1: Assigned weights for the calculation of CPI

Category

Weight

Food and beverages

46%

Miscellaneous (including petrol and diesel, health, and education)

28%

Housing

10%

Clothing and footwear

7%

Fuel and light

7%

Pan, tobacco, and intoxications

2%

Total

100%

Sources: MOSPI; PRS.

Table 2: Average inflation of some CPI components
between February 2022 to August 2022 (in percentage)

Subcategory of CPI

Average inflation

Vegetables 

13.26%

Oils and fats

12.46%

Footwear

11.41%

Fuel and Light

9.88%

Transport and communication

7.74%

Cereals and products

6.05%

Sources: Database on Indian Economy, RBI; PRS.

CPI is not the only index that measures inflation in an economy. The Wholesale Price Index (WPI) measures the wholesale prices of goods. A change in wholesale prices reflects wholesale inflation. Table 3 indicates the weights assigned to goods for calculating the WPI. Manufactured goods include metals, chemicals, food products, and textiles.   

Primary articles (23%) include food articles, and crude petroleum and natural gas. Fuel and power (12%) include mineral oils, electricity, and coal.  WPI has remained above 10% from April 2021 onwards. It reached an all-time high of 17% in May 2022. This was driven by the inflation in metals, kerosene and petroleum coke, fruits and vegetables, and palm oil.

Table 3:Assigned weights for the
calculation of WPI (in percentage)

Category

Weight

Manufactured products

64%

Primary articles

23%

Fuel and power

12%

All commodities

100%

Sources: Ministry of Commerce and Industry; PRS.

Why has WPI inflation been consistently above CPI inflation?

Movements in the WPI have an impact on the CPI.  For almost a year and half, CPI inflation has remained below WPI inflation.  However, as per the design of the indices, it is expected that CPI would remain above WPI, and that any increase in WPI would reflect in the CPI after a time lag.  This is because retail prices include taxes (as a percentage of price), while wholesale prices do not.  Additionally, some of the goods in WPI act as inputs in the goods considered in CPI.  An increase in input prices would lead to higher retail prices after a time lag.

We discuss possible reasons for why CPI has remained below WPI for a year and a half.

Figure 2: Consumer Price Index and Wholesale Price Index

image

Sources: Database on Indian Economy, Reserve Bank of India; PRS.

Composition of indices

As indicated in Table 2 and 3, the composition of the two indices varies. For instance, prices of manufacture of basic metals, chemicals, and machinery grew at an average rate of 13% between February 2021 and September 2022.  They contribute 7% to the WPI. These are input goods for producing final goods and services such as automobiles, which are included in the CPI. The rise in prices of transport vehicles, communication devices, fuel for transport, and housing (CPI components) rose by 6% during this period.

The Ministry of Finance has observed that wholesale prices did not feed into retail prices (from March 2021 onwards) as wholesalers absorbed the rising input costs and did not pass them on to retailers. In August 2022, it noted that as retail prices are rising now, the pass-through may occur.