The first batch of B.Tech students will pass out in the next couple of months from six new IITs but they will not get their degrees unless Parliament passes an Amendment Bill.  M.Tech students who completed their course in IIT Hyderabad last year have not yet been awarded their degrees. The Institute of Technology (Amendment) Bill, 2010 is listed for consideration and passing in the Rajya Sabha on April 30, 2012 along with the National Institutes of Technology (Amendment) Bill, 2010.  Both Bills were passed in the Lok Sabha in 2011Both Bills confer the status of institutions of national importance to a number of new institutions, which implies that they have the power to award degrees (other technical institutions have to be affiliated with a university to be able to award degrees).  These institutions cannot award degrees until Rajya Sabha also passes the Bill, the President gives assent and the central government brings it into effect through a notification. Power to grant degrees The Ministry of HRD established six new Indian Institutes Technology (IITs) in 2008 and two in 2009.  It also established five new Indian Institutes of Science Education and Research (IISERs).  However, they are still awaiting for the power to be recognised as degree granting institutions.  Entry 64 of the Union List states that only Parliament can declare an institution to be an institution of national importance (see here and here).  Also, the University Grants Commission Act, 1956 states that the right to confer degrees can be exercised only by a university, deemed university or any institution specially empowered by an Act of Parliament to do so. According to news reports, students of the new IISERs who passed out in 2011 have not received their degrees because of the legislative delay.  Similar problems were reported by students in IIT-Benaras Hindu University.  The students of the new IITs, which were set up in 2008 would be passing out this year.  It is likely that they would face similar problems.  In fact, IIT-Hyderabad is already in the news for not being able to award degree to its Masters students. Highlights of the Bills The Institute of Technology (Amendment) Bill, 2010 amends the Institutes of Technology Act, 1961, which declares certain Institutes of Technology to be institutions of national importance by adding eight new Indian Institutes of Technology (IITs) in Bhubaneshwar, Gandhinagar, Hyderabad, Indore, Jodhpur, Mandi, Patna, Ropar.  It also seeks to integrate the Institute of Technology, Banaras Hindu University (BHU) within the ambit of the Act.  All these institutions shall be declared as institutions of national importance (see here for a Bill Summary). The Bill was referred to the Standing Committee on HRD, which raised a few issues with regard to lack of clarity about the zone in which IIT-BHU shall be operating, the need to preserve the autonomy of the IITs and the need to fulfil qualitative parameters before the new IITs could transform into institutes of national importance (see here for the Standing Committee Report and a Summary). The National Institutes of Technology (Amendment) Bill, 2010 amends the National Institutes of Technology Act, 2007 to add a schedule of five Indian Institutes of Science Education and Research (IISER) (established in Kolkata, Pune, Mohali, Bhopal and Thiruvananthapuram).  These institutions shall be declared to be institutions of national importance.  Currently, there are 20 institutions listed as institutions of national importance under the 2007 Act (see here for a Bill Summary). The Standing Committee Report on the Bill made a few recommendations: (a) the composition of the Board of Governors should be made more expert specific in with the mandate of IISERs; (b) IISER Council should have less number of Secretaries, and (c) details of the inter-disciplinary knowledge regime should strive toward flexibility and freedom in research (see here for the Standing Committee Report and a Summary).

Recently, the Supreme Court collegium reiterated its recommendations for the appointment of 11 judges to certain High Courts.  It had first recommended these names earlier this year and in August last year, but these appointments were not made.  The Indian judiciary faces high vacancies across all levels (the Supreme Court, High Courts, and subordinate courts).  Vacancy of judges in courts is one of the reasons for delays and a rising number of pending cases, as there are not enough judges to hear and decide cases.  As of today, more than four crore cases are pending across all courts in India.   In this blog post, we discuss vacancies across courts over the years, delays in appointment of judges, and methods to determine the adequate judge strength required to handle the caseload courts face.

High vacancy of judges across courts

Vacancies in courts keep on arising periodically due to retirement, resignation, demise, or elevation of judges.  Over the years, the sanctioned strength of judges in both High Courts and subordinate courts has been increased gradually.  However, vacancies persist due to insufficient appointments (see Figures 1 and 2).  Between 2010 and 2020, vacancies increased from 18% to 21% across all levels of courts (from 6% to 12% in the Supreme Court, from 33% to 38% in High Courts, and from 18% to 20% in subordinate courts). 

Figure 1: Vacancy of judges in High Courts

Figure 2: Vacancy of judges in subordinate courts

image

image

Sources: Court News 2010-2018; Vacancy Statement, and Rajya Sabha replies, Part I, Budget Session (2021), Department of Justice; PRS.

As on November 1, 2021, the Supreme Court had a vacancy of one judge (out of a sanctioned strength of 34).  Vacancy in High Courts stood at 37% (406 posts vacant out of a sanctioned strength of 1,098).  Since May, 2021, the Supreme Court collegium has recommended more than 130 names for appointment as High Court judges.  In three High Courts (Telangana, Patna, and Calcutta), at least half of the posts are vacant (see Figure 3).  The Standing Committee on Personnel, Public Grievances, Law and Justice (2020) noted that every year, 35-40% of posts of High Court judges remain unfilled. 

Figure 3: Vacancy of judges across High Courts (in %) (as on November 1, 2021)

image

Source: Vacancy Statement, Department of Justice; PRS.

 

 

 

 

 

 

 

 

 

Appointments of High Court judges are guided by a memorandum of procedure.  As per this memorandum, the appointment process is to be initiated by the concerned High Court at least six months before a vacancy occurs.  However, the Standing Committee (2021) noted that this timeline is rarely adhered to by High Courts.  Further, in the final stage of the process, after receiving recommendations from the Supreme Court collegium, the executive appoints judges to the High Court.  No timeline is prescribed for this stage of the appointment process.  In 2018 and 2019, the average time taken to appoint High Court judges after receiving the collegium’s recommendations was five to seven months.

As of today, over 3.6 crore cases are pending before subordinate courts in India.  As on February 20, 2020, 21% posts for judges were vacant (5,146 posts out of the sanctioned strength of 24,018) in subordinate courts.  Subordinate courts in Bihar, Haryana, and Jharkhand (among the states with high population) had a high proportion of vacancies of judges (see Figure 4).  Note that the Supreme Court is monitoring the procedure for appointment of judges to subordinate courts.

For an analysis of the data on pendency and vacancies in the Indian judiciary, see here.

Figure 4: Vacancy of judges across subordinate courts (in %) (as on February 20, 2020)

image

Source: Report No. 101, Standing Committee on Personnel, Public Grievances, Law and Justice (2020); PRS.

 

How many judges do we need?

The Law Commission of India (1987) had noted the importance of manpower planning for the judiciary.  Lack of adequate number of judges means a greater workload per judge.  Thus, it becomes essential to arrive at an optimal judge strength to deal with pending and new cases in courts.  Over the years, different methods of calculating the required judge strength for subordinate courts (where the backlog of cases in the Indian judiciary is concentrated) have been recommended (see Table 1). 

Table 1: Methods recommended for calculating the required number of judges for subordinate courts

Method of calculation

Recommendation and its status

Judge-to-population ratio: optimum number of judges per million population

The Law Commission of India (1987) had recommended increasing this ratio to 50 judges per million people.  This was reiterated by the Supreme Court (2001) and the Standing Committee on Home Affairs (2002).  For 2020, the judge-to-population ratio was 21 judges per million population.     Note that this figure is calculated based on the sanctioned strength of judges in the Supreme Court, High Courts and subordinate courts.

Rate of disposal: number of additional judges required (to clear the existing backlog of cases and ensure that new backlog is not created) based on the average number of cases disposed per judge

The Law Commission of India (2014) proposed this method.  It rejected the judge-to-population ratio method, observing that filing of cases per capita varies substantially across geographic units depending on socio-economic conditions.

Weighted case load method: calculating judge strength based on the disposal by judges, taking into account the nature and complexity of cases in local conditions

The National Court Management Systems Committee (NCMS) (2016) critiqued the rate of disposal method.     It proposed, as an interim measure, the weighted case load method, which addresses the existing backlog of cases as well as the new flow of cases every year in subordinate courts.     In 2017, the Supreme Court accepted this model.

Time-based weighted case load method: calculating the required judge strength taking into account the actual time spent by judges in different types of cases at varying stages based on an empirical study

Used widely in the United States, this was the long-term method recommended by the NCMS (2016) to assess the required judge strength for subordinate courts.  It involves determining the total number of ‘judicial hours’ required for disposing of the case load of each court.  The Delhi High Court used this approach in a pilot project (January 2017- December 2018) to calculate the ideal judge strength for disposing of pending cases in certain courts in Delhi.

Sources: Reports No. 120 (1987) and 245 (2014), Law Commission of India; Report No. 85, Standing Committee on Home Affairs (2002); Note for Calculating Required Judge Strength for Subordinate Courts, National Court Management Systems Committee (NCMS) (2016); Imtiyaz Ahmad vs. State of Uttar Pradesh, Supreme Court (2017); PRS.