Recently, there have been reports of price crashes and distress sales in case of farm produce, such as tomatoes, mangoes, and garlic. In some cases, farmers have dumped their produce on roads. Produce such as fruits and vegetables are perishable and therefore have a short shelf life. Further, due to inadequate storage facilities and poor food processing infrastructure farmers have limited options but to sell the produce at prevailing market prices. This can lead to distress sales or roadside discards (in some cases to avoid additional cost of transportation).
Food processing allows raw food to be stored, marketed, or preserved for consumption later. For instance, raw agricultural produce such as fruits may be processed into juices, jams, and pickles. Activities such as waxing (for preservation), packaging, labelling, or ripening of produce also form part of the food processing industry.
Between 2001-02 and 2016-17, production of food grains grew annually at 1.7% on average. Production of horticulture crops surpassed food grains with an average growth rate of 4.8%. While production has been increasing over the years, surplus produce tends to go waste at various stages such as procurement, storage, and processing due to lack of infrastructure such as cold storages and food processing units.
Source: Horticulture Statistics at a Glance 2017, Union Budget 2018-19; PRS.
Losses high among perishables such as fruits and vegetables
Crop losses ranged between 7-16% among fruits and around 5% among cereals in 2015. The highest losses were witnessed in case of guava, followed by mango, which are perishable fruits. Perishables such as fruits and vegetables are more prone to losses as compared to cereals. Such crop losses can occur during operations such as harvesting, thrashing, grading, drying, packaging, transportation, and storage depending upon the commodity.
It was estimated that the annual value of harvest and post-harvest losses of major agricultural products at the national level was Rs 92,651 crore in 2015. The Standing Committee on Agriculture (2017) stated that such wastage can be reduced with adequate food processing facilities.
Sources: Annual Report 2016-17, Ministry of Food Processing Industries; PRS.
Inadequate food processing infrastructure
As previously discussed, perishables such as fruits and vegetables are more prone to damages as compared to cereals. Due to inadequate processing facilities in close proximity, farmers may be unable to hold their produce for a long time. Hence, they may be forced to sell their produce soon after harvest, irrespective of the prevailing market situations. Expert committees have recommended that agri-logistics such as cold chain infrastructure and market linkages should be strengthened.
Cold chain infrastructure: Cold chain infrastructure includes processing units, cold storages, and refrigerated vans. As of 2014, out of a required cold storage capacity of 35 million metric tonnes (MT), almost 90% (31.8 million MT) of the capacity was available (see Table 1). However, cold storage needs to be coupled with logistical support to facilitate smooth transfer of harvested value from farms to distant locations. This includes: (i) pack-houses for packaging and preparing fresh produce for long distance transport, (ii) refrigerated transport such as reefer vehicles, and (iii) ripening chambers to ripen raw produce before marketing. For instance, bananas which are harvested raw may be ripened in these chambers before being marketed.
While there are sufficient cold storages, there are wide gaps in the availability of other associated infrastructure. This implies that even though almost 90% (32 million tonnes) of cold storage capacity is available, only 15% of the required refrigerated transport exists. Further, the shortfall in the availability of infrastructure necessary for safe handling of farm produce, like pack-houses and ripening chambers, is over 90%.
Table 1: Gaps in cold chain infrastructure (2014)
| Facility | Required | Available | Gap | % gap |
| Cold storage (in million MT) |
35.1 |
31.8 | 3.2 |
9.3% |
| Pack-houses |
70,080 |
249 | 69,831 |
99.6% |
| Reefer vehicles |
61,826 |
9,000 | 52,826 |
85.4% |
| Ripening chambers |
9,131 |
812 | 8,319 |
91.1% |
To minimise post-harvest losses, the Standing Committee (2017) recommended that a country-wide integrated cold chain infrastructure network at block and district levels should be created. It further recommended that a Cold Chain Coordination and Monitoring Committee should be constituted at the district-level. The Standing Committee also recommended that farmers need to be trained in value addition activities such as sorting, grading, and pre-cooling harvested produce through facilities such as freezers and ripening chambers.
Between 2008 and 2017, 238 cold chain projects were sanctioned under the Scheme for Integrated Cold Chain and Value Addition Infrastructure. Grants worth Rs 1,775 crore were approved for these projects. Of this amount, Rs 964 crore (54%) has been released as of January 2018. Consequently, out of the total projects sanctioned, 114 (48%) are completed. The remaining 124 projects are currently under implementation.
Transport Facilities: Currently, majority of food grains and certain quantities of tea, potato, and onion are transported through railways. The Committee on Doubling Farmers Income had recommended that railways needs to upgrade its logistics to facilitate the transport of fresh produce directly to export hubs. This includes creation of adjoining facilities for loading and unloading, and distribution to road transport.
Mega Food Parks: The Mega Food Parks scheme was launched in 2008. It seeks to facilitate setting up of food processing units. These units are to be located at a central processing centre with infrastructure required for processing, packaging, quality control labs, and trade facilitation centres.
As of March 2018, out of the 42 projects approved, 10 were operational. The Standing Committee on Agriculture noted certain reasons for delay in implementation of projects under the scheme. These include: (i) difficulty in getting loans from banks for the project, (ii) delay in obtaining clearances from the state governments and agencies for roads, power, and water at the project site, (iii) lack of special incentives for setting up food processing units in Mega Food Parks, and (iv) unwillingness of the co-promoters in contributing their share of equity.
Further, the Standing Committee stated that as the scheme requires a minimum area of 50 acres, it does not to promote smaller or individual food processing and preservation units. It recommended that smaller agro-processing clusters near production areas must be promoted. The Committee on Doubling Farmers Income recommended establishment of processing and value addition units at strategic places. This includes rural or production areas for pulses, millets, fruits, vegetables, dairy, fisheries, and poultry in public private-partnership mode.
Last week, the Planning Commission filed an affidavit in the Supreme Court updating the official poverty line to Rs 965 per month in urban areas and Rs 781 in rural areas. This works out to Rs 32 and and Rs 26 per day, respectively. The perceived inadequacy of these figures has led to widespread discussion and criticism in the media. In light of the controversy, it may be worth looking at where the numbers come from in the first place. Two Measures of the BPL Population The official poverty line is determined by the Planning Commission, on the basis of data provided by the National Sample Survey Organisation (NSSO). NSSO data is based on a survey of consumer expenditure which takes place every five years. The most recent Planning Commission poverty estimates are for the year 2004-05. In addition to Planning Commission efforts to determine the poverty line, the Ministry of Rural Development has conducted a BPL Census in 1992, 1997, 2002, and 2011 to identify poor households. The BPL Census is used to target families for assistance through various schemes of the central government. The 2011 BPL Census is being conducted along with a caste census, and is dubbed the Socio-Economic & Caste Census (SECC) 2011. Details on the methodology of SECC 2011 are available in this short Ministry of Rural Development circular. Planning Commission Methodology Rural and urban poverty lines were first defined in 1973-74 in terms of Per Capita Total Expenditure (PCTE). Consumption is measured in terms of a collection of goods and services known as reference Poverty Line Baskets (PLB). These PLB were determined separately for urban and rural areas and based on a per-day calorie intake of 2400 (rural) and 2100 (urban), each containing items such as food, clothing, fuel, rent, conveyance and entertainment, among others. The official poverty line is the national average expenditure per person incurred to obtain the goods in the PLB. Since 1973-74, prices for goods in the PLB have been periodically adjusted over time and across states to deduce the official poverty line. Uniform Reference Period (URP) vs Mixed Reference Period (MRP) Until 1993-94, consumption information collected by the NSSO was based on the Uniform Reference Period (URP), which measured consumption across a 30-day recall period. That is, survey respondents were asked about their consumption in the previous 30 days. From 1999-2000 onwards, the NSSO switched to a method known as the Mixed Reference Period (MRP). The MRP measures consumption of five low-frequency items (clothing, footwear, durables, education and institutional health expenditure) over the previous year, and all other items over the previous 30 days. That is to say, for the five items, survey respondents are asked about consumption in the previous one year. For the remaining items, they are asked about consumption in the previous 30 days. Tendulkar Committee Report In 2009, the Tendulkar Committee Report suggested several changes to the way poverty is measured. First, it recommended a shift away from basing the PLB in caloric intake and towards target nutritional outcomes instead. Second, it recommended that a uniform PLB be used for both rural and urban areas. In addition, it recommended a change in the way prices are adjusted, and called for an explicit provision in the PLB to account for private expenditure in health and education. For these reasons, the Tendulkar estimate of poverty for the years 1993-94 and 2004-05 is higher than the official estimate, regardless of whether one looks at URP or MRP figures. For example, while the official 1993-94 All-India poverty figure is 36% (URP), applying the Tendulkar methodology yields a rate of 45.3%. Similarly, the official 2004-05 poverty rate is 21.8% (MRP) or 27.5% (URP), while applying the the Tendulkar methodology brings the number to 37.2%. A Planning Commission table of poverty rates by state comparing the two methodologies by is available here.
