Recently, there have been reports of price crashes and distress sales in case of farm produce, such as tomatoesmangoes, and garlic.  In some cases, farmers have dumped their produce on roads.  Produce such as fruits and vegetables are perishable and therefore have a short shelf life.  Further, due to inadequate storage facilities and poor food processing infrastructure farmers have limited options but to sell the produce at prevailing market prices.  This can lead to distress sales or roadside discards (in some cases to avoid additional cost of transportation).

Food processing allows raw food to be stored, marketed, or preserved for consumption later.  For instance, raw agricultural produce such as fruits may be processed into juices, jams, and pickles.  Activities such as waxing (for preservation), packaging, labelling, or ripening of produce also form part of the food processing industry.

Between 2001-02 and 2016-17, production of food grains grew annually at 1.7% on average.  Production of horticulture crops surpassed food grains with an average growth rate of 4.8%.  While production has been increasing over the years, surplus produce tends to go waste at various stages such as procurement, storage, and processing due to lack of infrastructure such as cold storages and food processing units.

Source: Horticulture Statistics at a Glance 2017, Union Budget 2018-19; PRS.

Source: Horticulture Statistics at a Glance 2017, Union Budget 2018-19; PRS.

Losses high among perishables such as fruits and vegetables

Crop losses ranged between 7-16% among fruits and around 5% among cereals in 2015.  The highest losses were witnessed in case of guava, followed by mango, which are perishable fruits.  Perishables such as fruits and vegetables are more prone to losses as compared to cereals.  Such crop losses can occur during operations such as harvesting, thrashing, grading, drying, packaging, transportation, and storage depending upon the commodity.

It was estimated that the annual value of harvest and post-harvest losses of major agricultural products at the national level was Rs 92,651 crore in 2015.  The Standing Committee on Agriculture (2017) stated that such wastage can be reduced with adequate food processing facilities.

Sources: Annual Report 2016-17, Ministry of Food Processing Industries; PRS.

Sources: Annual Report 2016-17, Ministry of Food Processing Industries; PRS.

Inadequate food processing infrastructure

As previously discussed, perishables such as fruits and vegetables are more prone to damages as compared to cereals.  Due to inadequate processing facilities in close proximity, farmers may be unable to hold their produce for a long time.  Hence, they may be forced to sell their produce soon after harvest, irrespective of the prevailing market situations.  Expert committees have recommended that agri-logistics such as cold chain infrastructure and market linkages should be strengthened.

Cold chain infrastructure: Cold chain infrastructure includes processing units, cold storages, and refrigerated vans.  As of 2014, out of a required cold storage capacity of 35 million metric tonnes (MT), almost 90% (31.8 million MT) of the capacity was available (see Table 1).  However, cold storage needs to be coupled with logistical support to facilitate smooth transfer of harvested value from farms to distant locations.  This includes: (i) pack-houses for packaging and preparing fresh produce for long distance transport, (ii) refrigerated transport such as reefer vehicles, and (iii) ripening chambers to ripen raw produce before marketing.  For instance, bananas which are harvested raw may be ripened in these chambers before being marketed.

While there are sufficient cold storages, there are wide gaps in the availability of other associated infrastructure.  This implies that even though almost 90% (32 million tonnes) of cold storage capacity is available, only 15% of the required refrigerated transport exists.  Further, the shortfall in the availability of infrastructure necessary for safe handling of farm produce, like pack-houses and ripening chambers, is over 90%.

Table 1:  Gaps in cold chain infrastructure (2014)

Facility Required Available Gap % gap
Cold storage
(in million MT)

35.1

31.8 3.2

9.3%

Pack-houses

70,080

249 69,831

99.6%

Reefer vehicles

61,826

9,000 52,826

85.4%

Ripening chambers

9,131

812 8,319

91.1%

Source: Standing Committee on Agriculture 2018; PRS.

To minimise post-harvest losses, the Standing Committee (2017) recommended that a country-wide integrated cold chain infrastructure network at block and district levels should be created.  It further recommended that a Cold Chain Coordination and Monitoring Committee should be constituted at the district-level.  The Standing Committee also recommended that farmers need to be trained in value addition activities such as sorting, grading, and pre-cooling harvested produce through facilities such as freezers and ripening chambers.

Between 2008 and 2017, 238 cold chain projects were sanctioned under the Scheme for Integrated Cold Chain and Value Addition Infrastructure.  Grants worth Rs 1,775 crore were approved for these projects.  Of this amount, Rs 964 crore (54%) has been released as of January 2018.  Consequently, out of the total projects sanctioned, 114 (48%) are completed.  The remaining 124 projects are currently under implementation.

Transport Facilities:  Currently, majority of food grains and certain quantities of tea, potato, and onion are transported through railways.  The Committee on Doubling Farmers Income had recommended that railways needs to upgrade its logistics to facilitate the transport of fresh produce directly to export hubs.  This includes creation of adjoining facilities for loading and unloading, and distribution to road transport.

Mega Food Parks: The Mega Food Parks scheme was launched in 2008.  It seeks to facilitate setting up of food processing units.  These units are to be located at a central processing centre with infrastructure required for processing, packaging, quality control labs, and trade facilitation centres.

As of March 2018, out of the 42 projects approved, 10 were operational.  The Standing Committee on Agriculture noted certain reasons for delay in implementation of projects under the scheme.  These include: (i) difficulty in getting loans from banks for the project, (ii) delay in obtaining clearances from the state governments and agencies for roads, power, and water at the project site, (iii) lack of special incentives for setting up food processing units in Mega Food Parks, and (iv) unwillingness of the co-promoters in contributing their share of equity.

Further, the Standing Committee stated that as the scheme requires a minimum area of 50 acres, it does not to promote smaller or individual food processing and preservation units.  It recommended that smaller agro-processing clusters near production areas must be promoted.  The Committee on Doubling Farmers Income recommended establishment of processing and value addition units at strategic places.  This includes rural or production areas for pulses, millets, fruits, vegetables, dairy, fisheries, and poultry in public private-partnership mode.

By Rohit and Jhalak Some Rajya Sabha seats will be contested over the next year.  The Presidential elections are also scheduled to be held in 2012.  The recent assembly elections has implications for both these elections.  The Presidential elections will depend on the strenght in the assemblies, in Lok Sabha and in Rajya Sabha (which could change over the next year).  Implications for Rajya Sabha Elections The composition of Rajya Sabha may undergo some changes.  A total of 12 Rajya Sabha seats are up for election in 2011.  This includes 6 seats from West Bengal, 3 from Gujarat and 1 each from Maharashtra, Tamil Nadu and Goa.  Another 65 seats, across 18 states, go for elections in early 2012.  The largest chunk of these seats comes from UP(10), followed by Andhra Pradesh(6), Bihar(6) and Maharashtra(6). Since Rajya Sabha members are elected by the elected members of the Legislative Assembly of the State, a change in the composition of the assembly can affect the election outcome.  We used the current assembly compositions to work out scenarios for Rajya Sabha in 2011 and 2012.  There could be alliances between parties for the Rajya Sabha elections, so we have estimated a range for each grouping (Scenario I and II) for 2012.  See Notes [1] and [2]. 

Parties/ Coalitions 2010 Scenario 2011 Scenario 2012
      I II
UPA 89 94 95 97
NDA 65 65 67 66
Left 22 19 14 14
BSP 18 18 19 19
SP 5 5 6 6
AIADMK 4 5 5 5
BJD 6 6 5 5
Other parties 18 18 20 19
Independent 6 6 5 5
Nominated 8 9 9 9
Total 241 245 245 245

Implications for the election of the President The President is elected in accordance with the provisions of Article 54 and 55 of the Constitution.  The electorate consists of the elected members of Lok Sabha, Rajya Sabha and all Legislative Assemblies.  Each MP/ MLA's vote has a pre-determined value based on the population they represent.  The election is held in accordance with the system of proportional representation by means of a single transferable vote.  The winning candidate must secure at least 50% of the total value of votes polled. (For details, refer to this Election Commission document).  There is no change in the Lok Sabha composition (unless there are bye-elections). Position in Legislative Assemblies After the recent round of assembly elections, the all-India MLA count adds up to:

UPA 1613
NDA 1106
Left 205
BSP 246
AIADMK 155
BJD 103
SP 95
Others 597

The above numbers can now be used to estimate the value of votes polled by each coalition. See Note [3]:

Value of votes cast Scenario - 1 Scenario - 2
UPA 439,437 440,853
NDA 307,737 307,029
Left 51,646 51,646
BSP 77,243 77,243
SP 38,531 38,531
AIADMK 36,392 36,392
BJD 28,799 28,799
Others 119,097 118,389
Total 1,098,882 1,098,882
Min. to be elected 549,442 549,442

The UPA has the highest value of votes polled but the figure is not sufficient to get its candidate elected.  Assuming that there are at most three candidates with significant support (UPA, NDA, and Left/Third Front), the winner will be the one who manages to bridge the gap with second preference votes.  On this factor, the UPA backed candidate is likely to hold the edge over others.  Notes: [1] At present, there are four vacant seats in Rajya Sabha (1 Maharashtra, 1 TN, 1 WB and 1 Nominated).  It is assumed that all these seats are filled up in 2011. [2] Three of the 11 nominated members in the current Rajya Sabha have declared their party affiliation as INC.  These have been included in the UPA count in the above analysis.  For the sake of simplicity, it is assumed that members who get nominated in 2011/ 12 are not aligned to any party/ coalition. [3] The above analysis is based on the assumption that the next set of assembly elections happen after the Presidential election.