The union government is reportedly considering a legislation to create anti-corruption units both at the centre and the states. Such institutions were first conceptualized by the Administrative Reforms Commission (ARC) headed by Morarji Desai in its report published in 1966. It recommended the creation of two independent authorities - the Lokpal at the centre and the Lokayuktas in the states. The first Lokpal Bill was introduced in Parliament in 1968 but it lapsed with the dissolution of Lok Sabha. Later Bills also met a similar fate. Though the Lokpal could not be created as a national institution, the interest generated led to the enactment of various state legislations. Maharashtra became the first state to create a Lokayukta in 1972. Presently more than 50% of the states have Lokayuktas, though their powers, and consequently their functioning varies significantly across states. Existing institutional framework The Central Vigilance Commission (CVC) and the Central Bureau of Investigation (CBI) are the two cornerstones of the existing institutional framework. However, the efficacy of the current system has been questioned. [1] Though the CVC (set up in 1964) is an independent agency directly responsible to the Parliament, its role is advisory in nature. It relies on the CBI for investigation and only oversees the bureaucracy; Ministers and Members of Parliament are out of its purview. Thus, presently there is no authority (other than Parliament itself) with the mandate to oversee actions of political functionaries. At the state level, similar vigilance and anti-corruption organisations exist, although the nature of these organisations varies across states. Karnataka Lokayukta Act The Karnataka Lokayukta is widely considered as the most active among the state anti-corruption units. [1] It was first set up in 1986 under the Karnataka Lokayukta Act, 1984. The Act was recently amended by the state government following the resignation of the Lokayukta, Justice Santosh Hegde. Justice Hegde had been demanding additional powers for the Lokayukta - especially the power to investigate suo-motu. Following the amendment, the Lokayukta has been given the suo motu powers to investigate all public servants except the CM, Ministers, Legislators and those nominated by the government. Following are the main provisions of the Karnataka Lokayukta Act:
The forthcoming Ordinance/ Bill Given that a Lokpal Bill is on the anvil, it might be useful at this point to enumerate some metrics/ questions against which the legislation should be tested:
What do you think? Write in with your comments. Notes: [1] Report of the Second Administrative Reforms Commission (ARC), 'Ethics in Governance' (2007) [2] Additional reading: An interview with the Karnataka Lokayukta
Recently, the Supreme Court collegium reiterated its recommendations for the appointment of 11 judges to certain High Courts. It had first recommended these names earlier this year and in August last year, but these appointments were not made. The Indian judiciary faces high vacancies across all levels (the Supreme Court, High Courts, and subordinate courts). Vacancy of judges in courts is one of the reasons for delays and a rising number of pending cases, as there are not enough judges to hear and decide cases. As of today, more than four crore cases are pending across all courts in India. In this blog post, we discuss vacancies across courts over the years, delays in appointment of judges, and methods to determine the adequate judge strength required to handle the caseload courts face.
High vacancy of judges across courts
Vacancies in courts keep on arising periodically due to retirement, resignation, demise, or elevation of judges. Over the years, the sanctioned strength of judges in both High Courts and subordinate courts has been increased gradually. However, vacancies persist due to insufficient appointments (see Figures 1 and 2). Between 2010 and 2020, vacancies increased from 18% to 21% across all levels of courts (from 6% to 12% in the Supreme Court, from 33% to 38% in High Courts, and from 18% to 20% in subordinate courts).
|
Figure 1: Vacancy of judges in High Courts |
Figure 2: Vacancy of judges in subordinate courts |
|
|
|
|
Sources: Court News 2010-2018; Vacancy Statement, and Rajya Sabha replies, Part I, Budget Session (2021), Department of Justice; PRS. |
|
As on November 1, 2021, the Supreme Court had a vacancy of one judge (out of a sanctioned strength of 34). Vacancy in High Courts stood at 37% (406 posts vacant out of a sanctioned strength of 1,098). Since May, 2021, the Supreme Court collegium has recommended more than 130 names for appointment as High Court judges. In three High Courts (Telangana, Patna, and Calcutta), at least half of the posts are vacant (see Figure 3). The Standing Committee on Personnel, Public Grievances, Law and Justice (2020) noted that every year, 35-40% of posts of High Court judges remain unfilled.
|
Figure 3: Vacancy of judges across High Courts (in %) (as on November 1, 2021)
|
|
Source: Vacancy Statement, Department of Justice; PRS. |
Appointments of High Court judges are guided by a memorandum of procedure. As per this memorandum, the appointment process is to be initiated by the concerned High Court at least six months before a vacancy occurs. However, the Standing Committee (2021) noted that this timeline is rarely adhered to by High Courts. Further, in the final stage of the process, after receiving recommendations from the Supreme Court collegium, the executive appoints judges to the High Court. No timeline is prescribed for this stage of the appointment process. In 2018 and 2019, the average time taken to appoint High Court judges after receiving the collegium’s recommendations was five to seven months.
As of today, over 3.6 crore cases are pending before subordinate courts in India. As on February 20, 2020, 21% posts for judges were vacant (5,146 posts out of the sanctioned strength of 24,018) in subordinate courts. Subordinate courts in Bihar, Haryana, and Jharkhand (among the states with high population) had a high proportion of vacancies of judges (see Figure 4). Note that the Supreme Court is monitoring the procedure for appointment of judges to subordinate courts.
For an analysis of the data on pendency and vacancies in the Indian judiciary, see here.
Figure 4: Vacancy of judges across subordinate courts (in %) (as on February 20, 2020)
|
|
|
Source: Report No. 101, Standing Committee on Personnel, Public Grievances, Law and Justice (2020); PRS. |
How many judges do we need?
The Law Commission of India (1987) had noted the importance of manpower planning for the judiciary. Lack of adequate number of judges means a greater workload per judge. Thus, it becomes essential to arrive at an optimal judge strength to deal with pending and new cases in courts. Over the years, different methods of calculating the required judge strength for subordinate courts (where the backlog of cases in the Indian judiciary is concentrated) have been recommended (see Table 1).
Table 1: Methods recommended for calculating the required number of judges for subordinate courts
|
Method of calculation |
Recommendation and its status |
|
Judge-to-population ratio: optimum number of judges per million population |
The Law Commission of India (1987) had recommended increasing this ratio to 50 judges per million people. This was reiterated by the Supreme Court (2001) and the Standing Committee on Home Affairs (2002). For 2020, the judge-to-population ratio was 21 judges per million population. Note that this figure is calculated based on the sanctioned strength of judges in the Supreme Court, High Courts and subordinate courts. |
|
Rate of disposal: number of additional judges required (to clear the existing backlog of cases and ensure that new backlog is not created) based on the average number of cases disposed per judge |
The Law Commission of India (2014) proposed this method. It rejected the judge-to-population ratio method, observing that filing of cases per capita varies substantially across geographic units depending on socio-economic conditions. |
|
Weighted case load method: calculating judge strength based on the disposal by judges, taking into account the nature and complexity of cases in local conditions |
The National Court Management Systems Committee (NCMS) (2016) critiqued the rate of disposal method. It proposed, as an interim measure, the weighted case load method, which addresses the existing backlog of cases as well as the new flow of cases every year in subordinate courts. In 2017, the Supreme Court accepted this model. |
|
Time-based weighted case load method: calculating the required judge strength taking into account the actual time spent by judges in different types of cases at varying stages based on an empirical study |
Used widely in the United States, this was the long-term method recommended by the NCMS (2016) to assess the required judge strength for subordinate courts. It involves determining the total number of ‘judicial hours’ required for disposing of the case load of each court. The Delhi High Court used this approach in a pilot project (January 2017- December 2018) to calculate the ideal judge strength for disposing of pending cases in certain courts in Delhi. |
Sources: Reports No. 120 (1987) and 245 (2014), Law Commission of India; Report No. 85, Standing Committee on Home Affairs (2002); Note for Calculating Required Judge Strength for Subordinate Courts, National Court Management Systems Committee (NCMS) (2016); Imtiyaz Ahmad vs. State of Uttar Pradesh, Supreme Court (2017); PRS.
