In light of the decision of the union cabinet to promulgate an Ordinance to uphold provisions of the Representation of People Act, 1951, this blog examines the Ordinance making power of the Executive in India. The Ordinance allows legislators (Members of Parliament and Members of Legislative Assemblies) to retain membership of the legislature even after conviction, if (a) an appeal against the conviction is filed before a court within 90 days and (b) the appeal is stayed by the court. However, the Ordinance will only be promulgated after it receives the assent of the President. I. Separation of powers between the Legislature, Executive and Judiciary In India, the central and state legislatures are responsible for law making, the central and state governments are responsible for the implementation of laws and the judiciary (Supreme Court, High Courts and lower courts) interprets these laws. However, there are several overlaps in the functions and powers of the three institutions. For example, the President has certain legislative and judicial functions and the legislature can delegate some of its functions to the executive in the form of subordinate legislation. II. Ordinance making powers of the President Article 123 of the Constitution grants the President certain law making powers to promulgate Ordinances when either of the two Houses of Parliament is not in session and hence it is not possible to enact laws in the Parliament.[i] An Ordinance may relate to any subject that the Parliament has the power to legislate on. Conversely, it has the same limitations as the Parliament to legislate, given the distribution of powers between the Union, State and Concurrent Lists. Thus, the following limitations exist with regard to the Ordinance making power of the executive: i. Legislature is not in session: The President can only promulgate an Ordinance when either of the two Houses of Parliament is not in session. ii. Immediate action is required: The President cannot promulgate an Ordinance unless he is satisfied that there are circumstances that require taking ‘immediate action’[ii]. iii. Parliamentary approval during session: Ordinances must be approved by Parliament within six weeks of reassembling or they shall cease to operate. They will also cease to operate in case resolutions disapproving the Ordinance are passed by both the Houses. Figure 1 shows the number of Ordinances that have been promulgated in India since 1990. The largest number of Ordinances was promulgated in 1993, and there has been a decline in the number of Ordinance promulgated since then. However, the past year has seen a rise in the number of Ordinances promulgated. Figure 1: Number of national Ordinances promulgated in India since 1990 
Source: Ministry of Law and Justice; Agnihotri, VK (2009) ‘The Ordinance: Legislation by the Executive in India when the Parliament is not in Session’; PRS Legislative Research III. Ordinance making powers of the Governor Just as the President of India is constitutionally mandated to issue Ordinances under Article 123, the Governor of a state can issue Ordinances under Article 213, when the state legislative assembly (or either of the two Houses in states with bicameral legislatures) is not in session. The powers of the President and the Governor are broadly comparable with respect to Ordinance making. However, the Governor cannot issue an Ordinance without instructions from the President in three cases where the assent of the President would have been required to pass a similar Bill.[iii] IV. Key debates relating to the Ordinance making powers of the Executive There has been significant debate surrounding the Ordinance making power of the President (and Governor). Constitutionally, important issues that have been raised include judicial review of the Ordinance making powers of the executive; the necessity for ‘immediate action’ while promulgating an Ordinance; and the granting of Ordinance making powers to the executive, given the principle of separation of powers. Table 1 provides a brief historical overview of the manner in which the debate on the Ordinance making powers of the executive has evolved in India post independence. Table 1: Key debates on the President's Ordinance making power
| Year |
Legislative development |
Key arguments |
| 1970 | RC Cooper vs. Union of India | In RC Cooper vs. Union of India (1970) the Supreme Court, while examining the constitutionality of the Banking Companies (Acquisition of Undertakings) Ordinance, 1969 which sought to nationalise 14 of India’s largest commercial banks, held that the President’s decision could be challenged on the grounds that ‘immediate action’ was not required; and the Ordinance had been passed primarily to by-pass debate and discussion in the legislature. |
| 1975 | 38th Constitutional Amendment Act | Inserted a new clause (4) in Article 123 stating that the President’s satisfaction while promulgating an Ordinance was final and could not be questioned in any court on any ground. |
| 1978 | 44th Constitutional Amendment Act | Deleted clause (4) inserted by the 38th CAA and therefore reopened the possibility for the judicial review of the President’s decision to promulgate an Ordinance. |
| 1980 | AK Roy vs. Union of India | In AK Roy vs. Union of India (1982) while examining the constitutionality of the National Security Ordinance, 1980, which sought to provide for preventive detention in certain cases, the Court argued that the President’s Ordinance making power is not beyond the scope of judicial review. However, it did not explore the issue further as there was insufficient evidence before it and the Ordinance was replaced by an Act. It also pointed out the need to exercise judicial review over the President’s decision only when there were substantial grounds to challenge the decision, and not at “every casual and passing challenge”. |
| 1985 | T Venkata Reddy vs. State of Andhra Pradesh | In T Venkata Reddy vs. State of Andhra Pradesh (1985), while deliberating on the promulgation of the Andhra Pradesh Abolition of Posts of Part-time Village Officers Ordinance, 1984 which abolished certain village level posts, the Court reiterated that the Ordinance making power of the President and the Governor was a legislative power, comparable to the legislative power of the Parliament and state legislatures respectively. This implies that the motives behind the exercise of this power cannot be questioned, just as is the case with legislation by the Parliament and state legislatures. |
| 1987 | DC Wadhwa vs. State of Bihar | It was argued in DC Wadhwa vs. State of Bihar (1987) the legislative power of the executive to promulgate Ordinances is to be used in exceptional circumstances and not as a substitute for the law making power of the legislature. Here, the court was examining a case where a state government (under the authority of the Governor) continued to re-promulgate ordinances, that is, it repeatedly issued new Ordinances to replace the old ones, instead of laying them before the state legislature. A total of 259 Ordinances were re-promulgated, some of them for as long as 14 years. The Supreme Court argued that if Ordinance making was made a usual practice, creating an ‘Ordinance raj’ the courts could strike down re-promulgated Ordinances. |
Source: Basu, DD (2010) Introduction to the Constitution of India; Singh, Mahendra P. (2008) VN Shukla's Constitution of India; PRS Legislative Research
This year, the following 9 Ordinances have been promulgated:
Three of these Ordinances have been re-promulgated, i.e., a second Ordinance has been promulgated to replace an existing one. This seems to be in violation of the Supreme Court’s decision in DC Wadhwa vs. State of Bihar.
Notes: [i] With regard to issuing Ordinances as with other matters, the President acts on the advice of the Council of Ministers. While the Ordinance is promulgated in the name of the President and constitutionally to his satisfaction, in fact, it is promulgated on the advice of the Council of Ministers.
[ii] Article 123, Clause (1)
[iii] (a) if a Bill containing the same provisions would have required the previous sanction of the President for introduction into the legislature; (b) if the Governor would have deemed it necessary to reserve a Bill containing the same provisions for the consideration of the President; and (c) if an Act of the legislature containing the same provisions would have been invalid unless it received the assent of the President.
Recently, there have been reports of price crashes and distress sales in case of farm produce, such as tomatoes, mangoes, and garlic. In some cases, farmers have dumped their produce on roads. Produce such as fruits and vegetables are perishable and therefore have a short shelf life. Further, due to inadequate storage facilities and poor food processing infrastructure farmers have limited options but to sell the produce at prevailing market prices. This can lead to distress sales or roadside discards (in some cases to avoid additional cost of transportation).
Food processing allows raw food to be stored, marketed, or preserved for consumption later. For instance, raw agricultural produce such as fruits may be processed into juices, jams, and pickles. Activities such as waxing (for preservation), packaging, labelling, or ripening of produce also form part of the food processing industry.
Between 2001-02 and 2016-17, production of food grains grew annually at 1.7% on average. Production of horticulture crops surpassed food grains with an average growth rate of 4.8%. While production has been increasing over the years, surplus produce tends to go waste at various stages such as procurement, storage, and processing due to lack of infrastructure such as cold storages and food processing units.
Source: Horticulture Statistics at a Glance 2017, Union Budget 2018-19; PRS.
Losses high among perishables such as fruits and vegetables
Crop losses ranged between 7-16% among fruits and around 5% among cereals in 2015. The highest losses were witnessed in case of guava, followed by mango, which are perishable fruits. Perishables such as fruits and vegetables are more prone to losses as compared to cereals. Such crop losses can occur during operations such as harvesting, thrashing, grading, drying, packaging, transportation, and storage depending upon the commodity.
It was estimated that the annual value of harvest and post-harvest losses of major agricultural products at the national level was Rs 92,651 crore in 2015. The Standing Committee on Agriculture (2017) stated that such wastage can be reduced with adequate food processing facilities.
Sources: Annual Report 2016-17, Ministry of Food Processing Industries; PRS.
Inadequate food processing infrastructure
As previously discussed, perishables such as fruits and vegetables are more prone to damages as compared to cereals. Due to inadequate processing facilities in close proximity, farmers may be unable to hold their produce for a long time. Hence, they may be forced to sell their produce soon after harvest, irrespective of the prevailing market situations. Expert committees have recommended that agri-logistics such as cold chain infrastructure and market linkages should be strengthened.
Cold chain infrastructure: Cold chain infrastructure includes processing units, cold storages, and refrigerated vans. As of 2014, out of a required cold storage capacity of 35 million metric tonnes (MT), almost 90% (31.8 million MT) of the capacity was available (see Table 1). However, cold storage needs to be coupled with logistical support to facilitate smooth transfer of harvested value from farms to distant locations. This includes: (i) pack-houses for packaging and preparing fresh produce for long distance transport, (ii) refrigerated transport such as reefer vehicles, and (iii) ripening chambers to ripen raw produce before marketing. For instance, bananas which are harvested raw may be ripened in these chambers before being marketed.
While there are sufficient cold storages, there are wide gaps in the availability of other associated infrastructure. This implies that even though almost 90% (32 million tonnes) of cold storage capacity is available, only 15% of the required refrigerated transport exists. Further, the shortfall in the availability of infrastructure necessary for safe handling of farm produce, like pack-houses and ripening chambers, is over 90%.
Table 1: Gaps in cold chain infrastructure (2014)
| Facility | Required | Available | Gap | % gap |
| Cold storage (in million MT) |
35.1 |
31.8 | 3.2 |
9.3% |
| Pack-houses |
70,080 |
249 | 69,831 |
99.6% |
| Reefer vehicles |
61,826 |
9,000 | 52,826 |
85.4% |
| Ripening chambers |
9,131 |
812 | 8,319 |
91.1% |
To minimise post-harvest losses, the Standing Committee (2017) recommended that a country-wide integrated cold chain infrastructure network at block and district levels should be created. It further recommended that a Cold Chain Coordination and Monitoring Committee should be constituted at the district-level. The Standing Committee also recommended that farmers need to be trained in value addition activities such as sorting, grading, and pre-cooling harvested produce through facilities such as freezers and ripening chambers.
Between 2008 and 2017, 238 cold chain projects were sanctioned under the Scheme for Integrated Cold Chain and Value Addition Infrastructure. Grants worth Rs 1,775 crore were approved for these projects. Of this amount, Rs 964 crore (54%) has been released as of January 2018. Consequently, out of the total projects sanctioned, 114 (48%) are completed. The remaining 124 projects are currently under implementation.
Transport Facilities: Currently, majority of food grains and certain quantities of tea, potato, and onion are transported through railways. The Committee on Doubling Farmers Income had recommended that railways needs to upgrade its logistics to facilitate the transport of fresh produce directly to export hubs. This includes creation of adjoining facilities for loading and unloading, and distribution to road transport.
Mega Food Parks: The Mega Food Parks scheme was launched in 2008. It seeks to facilitate setting up of food processing units. These units are to be located at a central processing centre with infrastructure required for processing, packaging, quality control labs, and trade facilitation centres.
As of March 2018, out of the 42 projects approved, 10 were operational. The Standing Committee on Agriculture noted certain reasons for delay in implementation of projects under the scheme. These include: (i) difficulty in getting loans from banks for the project, (ii) delay in obtaining clearances from the state governments and agencies for roads, power, and water at the project site, (iii) lack of special incentives for setting up food processing units in Mega Food Parks, and (iv) unwillingness of the co-promoters in contributing their share of equity.
Further, the Standing Committee stated that as the scheme requires a minimum area of 50 acres, it does not to promote smaller or individual food processing and preservation units. It recommended that smaller agro-processing clusters near production areas must be promoted. The Committee on Doubling Farmers Income recommended establishment of processing and value addition units at strategic places. This includes rural or production areas for pulses, millets, fruits, vegetables, dairy, fisheries, and poultry in public private-partnership mode.
