In light of the decision of the union cabinet to promulgate an Ordinance to uphold provisions of the Representation of People Act, 1951, this blog examines the Ordinance making power of the Executive in India. The Ordinance allows legislators (Members of Parliament and Members of Legislative Assemblies) to retain membership of the legislature even after conviction, if (a) an appeal against the conviction is filed before a court within 90 days and (b) the appeal is stayed by the court. However, the Ordinance will only be promulgated after it receives the assent of the President. I. Separation of powers between the Legislature, Executive and Judiciary In India, the central and state legislatures are responsible for law making, the central and state governments are responsible for the implementation of laws and the judiciary (Supreme Court, High Courts and lower courts) interprets these laws. However, there are several overlaps in the functions and powers of the three institutions. For example, the President has certain legislative and judicial functions and the legislature can delegate some of its functions to the executive in the form of subordinate legislation. II. Ordinance making powers of the President Article 123 of the Constitution grants the President certain law making powers to promulgate Ordinances when either of the two Houses of Parliament is not in session and hence it is not possible to enact laws in the Parliament.[i] An Ordinance may relate to any subject that the Parliament has the power to legislate on. Conversely, it has the same limitations as the Parliament to legislate, given the distribution of powers between the Union, State and Concurrent Lists. Thus, the following limitations exist with regard to the Ordinance making power of the executive: i. Legislature is not in session: The President can only promulgate an Ordinance when either of the two Houses of Parliament is not in session. ii. Immediate action is required: The President cannot promulgate an Ordinance unless he is satisfied that there are circumstances that require taking ‘immediate action’[ii]. iii. Parliamentary approval during session: Ordinances must be approved by Parliament within six weeks of reassembling or they shall cease to operate. They will also cease to operate in case resolutions disapproving the Ordinance are passed by both the Houses. Figure 1 shows the number of Ordinances that have been promulgated in India since 1990. The largest number of Ordinances was promulgated in 1993, and there has been a decline in the number of Ordinance promulgated since then. However, the past year has seen a rise in the number of Ordinances promulgated. Figure 1: Number of national Ordinances promulgated in India since 1990 
Source: Ministry of Law and Justice; Agnihotri, VK (2009) ‘The Ordinance: Legislation by the Executive in India when the Parliament is not in Session’; PRS Legislative Research III. Ordinance making powers of the Governor Just as the President of India is constitutionally mandated to issue Ordinances under Article 123, the Governor of a state can issue Ordinances under Article 213, when the state legislative assembly (or either of the two Houses in states with bicameral legislatures) is not in session. The powers of the President and the Governor are broadly comparable with respect to Ordinance making. However, the Governor cannot issue an Ordinance without instructions from the President in three cases where the assent of the President would have been required to pass a similar Bill.[iii] IV. Key debates relating to the Ordinance making powers of the Executive There has been significant debate surrounding the Ordinance making power of the President (and Governor). Constitutionally, important issues that have been raised include judicial review of the Ordinance making powers of the executive; the necessity for ‘immediate action’ while promulgating an Ordinance; and the granting of Ordinance making powers to the executive, given the principle of separation of powers. Table 1 provides a brief historical overview of the manner in which the debate on the Ordinance making powers of the executive has evolved in India post independence. Table 1: Key debates on the President's Ordinance making power
| Year |
Legislative development |
Key arguments |
| 1970 | RC Cooper vs. Union of India | In RC Cooper vs. Union of India (1970) the Supreme Court, while examining the constitutionality of the Banking Companies (Acquisition of Undertakings) Ordinance, 1969 which sought to nationalise 14 of India’s largest commercial banks, held that the President’s decision could be challenged on the grounds that ‘immediate action’ was not required; and the Ordinance had been passed primarily to by-pass debate and discussion in the legislature. |
| 1975 | 38th Constitutional Amendment Act | Inserted a new clause (4) in Article 123 stating that the President’s satisfaction while promulgating an Ordinance was final and could not be questioned in any court on any ground. |
| 1978 | 44th Constitutional Amendment Act | Deleted clause (4) inserted by the 38th CAA and therefore reopened the possibility for the judicial review of the President’s decision to promulgate an Ordinance. |
| 1980 | AK Roy vs. Union of India | In AK Roy vs. Union of India (1982) while examining the constitutionality of the National Security Ordinance, 1980, which sought to provide for preventive detention in certain cases, the Court argued that the President’s Ordinance making power is not beyond the scope of judicial review. However, it did not explore the issue further as there was insufficient evidence before it and the Ordinance was replaced by an Act. It also pointed out the need to exercise judicial review over the President’s decision only when there were substantial grounds to challenge the decision, and not at “every casual and passing challenge”. |
| 1985 | T Venkata Reddy vs. State of Andhra Pradesh | In T Venkata Reddy vs. State of Andhra Pradesh (1985), while deliberating on the promulgation of the Andhra Pradesh Abolition of Posts of Part-time Village Officers Ordinance, 1984 which abolished certain village level posts, the Court reiterated that the Ordinance making power of the President and the Governor was a legislative power, comparable to the legislative power of the Parliament and state legislatures respectively. This implies that the motives behind the exercise of this power cannot be questioned, just as is the case with legislation by the Parliament and state legislatures. |
| 1987 | DC Wadhwa vs. State of Bihar | It was argued in DC Wadhwa vs. State of Bihar (1987) the legislative power of the executive to promulgate Ordinances is to be used in exceptional circumstances and not as a substitute for the law making power of the legislature. Here, the court was examining a case where a state government (under the authority of the Governor) continued to re-promulgate ordinances, that is, it repeatedly issued new Ordinances to replace the old ones, instead of laying them before the state legislature. A total of 259 Ordinances were re-promulgated, some of them for as long as 14 years. The Supreme Court argued that if Ordinance making was made a usual practice, creating an ‘Ordinance raj’ the courts could strike down re-promulgated Ordinances. |
Source: Basu, DD (2010) Introduction to the Constitution of India; Singh, Mahendra P. (2008) VN Shukla's Constitution of India; PRS Legislative Research
This year, the following 9 Ordinances have been promulgated:
Three of these Ordinances have been re-promulgated, i.e., a second Ordinance has been promulgated to replace an existing one. This seems to be in violation of the Supreme Court’s decision in DC Wadhwa vs. State of Bihar.
Notes: [i] With regard to issuing Ordinances as with other matters, the President acts on the advice of the Council of Ministers. While the Ordinance is promulgated in the name of the President and constitutionally to his satisfaction, in fact, it is promulgated on the advice of the Council of Ministers.
[ii] Article 123, Clause (1)
[iii] (a) if a Bill containing the same provisions would have required the previous sanction of the President for introduction into the legislature; (b) if the Governor would have deemed it necessary to reserve a Bill containing the same provisions for the consideration of the President; and (c) if an Act of the legislature containing the same provisions would have been invalid unless it received the assent of the President.
The counting of votes for General Election 2019, which concluded on Sunday, will begin tomorrow, i.e., 23rd May at 8 AM. The election was conducted in 7 phases for 543 constituencies of Lok Sabha. The Election Commission of India (ECI) uses Electronic Voting Machines (EVM) to conduct elections. Since 2000, ECI has conducted 113 assembly elections and three general elections using EVMs.[1] Voter Verified Paper Audit Trail (VVPAT) system was added to EVMs in 2013 to increase transparency and improve voter confidence in the system. The VVPAT system generates a printed paper slip bearing the name and election symbol of the candidate. On April 8, 2019, Supreme Court instructed the ECI that printed VVPAT slips from randomly selected five polling stations in each assembly segment of a parliamentary constituency should be matched with EVMs.[2] In this blog, we explain the election counting process in India.
Who is responsible for counting the votes?
The Returning Officer (RO) is responsible for conducting elections in a constituency, which also includes counting of votes.[3] The RO is an officer of the government or a local authority nominated by the ECI for each constituency in consultation with the state government.[4]
Where does the counting take place?
The RO decides the place where the votes will be counted for the parliamentary constituency. The date and time of counting is fixed by the ECI. Ideally counting of votes for a constituency should be done at one place, preferably at the Headquarter of the RO in that constituency. It should be performed under the direct supervision of the RO. However, each Parliamentary Constituency has multiple assembly segments. In this situation, counting can take place at different locations for various assembly segments under the direct supervision of an Assistant Returning Officer (ARO).
Layout of the Counting Hall
Page 431, Handbook for Returning Officer Document 23 Edition 1, Election Commission of India
Counting of votes for each assembly segment of a parliamentary constituency is performed in a single hall. In each round of counting, votes from 14 EVMs are counted. In case of simultaneous parliamentary and assembly elections, such as Odisha, the first seven tables are used for counting votes for assembly elections, and the rest for parliamentary elections.
In constituencies with a large number of candidates, it may not be possible to count votes for all candidates in a single hall without overcrowding it. In such a situation, the number of counting halls or tables can be increased with the prior permission of the ECI. A hall can also be used for counting votes of another assembly segment after the results of the first segment are declared. However, counting may be done for only one assembly segment in a hall at any point of time.
What is the counting process?
Counting is performed by counting supervisors appointed by the RO. Counting staff is appointed through a three stage randomisation process to ensure impartiality. Candidates along with their counting agents and election agents are also present in the counting hall.
Counting of votes begins with Electronically Transmitted Postal Ballots (ETPB) and Postal Ballots (PB). These votes are counted under the direct supervision of the RO. Counting of EVMs can start 30 minutes after the commencement of PB counting, even if all PBs have not been counted. At the end of each round of counting, the results from 14 EVMs are declared.
What is the process for counting VVPAT slips?
The ECI prescribes the process for randomly selecting one EVM for each assembly segment of a parliamentary constituency for VVPAT matching. The verification of VVPAT paper slips is conducted inside a secured VVPAT Counting Booth in the counting hall with access to authorised personnel only. Any counting table in the hall can be converted into VVPAT Counting Booth after completing EVM vote counting. Parliamentary constituencies generally have between five and ten assembly segments.
The Supreme Court has decided that VVPAT slips of five randomly selected polling stations for each assembly segment shall be matched with the result shown in the respective EVMs. This implies that VVPAT paper slips need to be matched for about 25-50 machines for each parliamentary constituency. This process requires personal supervision of RO/ARO. The ECI has decided that the counting of five VVPATs will be done sequentially.[5] The RO can declare the final result for the constituency after the VVPAT matching process has been completed.
What happens if there is a discrepancy between the VVPAT count and the EVM results?
In such a case, the printed paper slips count is taken as final. The ECI has not clarified whether there would be any further action (such as counting of all VVPATs in a constituency or assembly segment) if there is a discrepancy in the counts of one of the five VVPATs.
[1] https://www.eci.gov.in/files/file/8756-status-paper-on-evm-edition-3/.
[2] N Chandrababu Naidu and Ors. v. Union of India and Anr WP(C). 273/2019 decided on April 8, 2019.
[3] https://www.eci.gov.in/files/file/9400-hand-book-for-returning-officer-february-2019/.
[4] https://www.eci.gov.in/faqs/elections/election-machinery/faqs-election-machinery-r1/.
[5] https://www.eci.gov.in/files/file/10197-mandatory-verification-of-vvpat-paper-slips-regarding/.
