Recently, the President repromulgated the Securities Laws (Amendment) Ordinance, 2014, which expands the Securities and Exchange Board Act’s (SEBI) powers related to search and seizure and permits SEBI to enter into consent settlements. The President also promulgated the Scheduled Castes and the Scheduled Tribes (Prevention of Atrocities) Amendment Ordinance, 2014, which establishes special courts for the trial of offences against members of Scheduled Castes and Scheduled Tribes. With the promulgation of these two Ordinances, a total of 25 Ordinances have been promulgated during the term of the 15th Lok Sabha so far. Ordinances are temporary laws which can be issued by the President when Parliament is not in session. Ordinances are issued by the President based on the advice of the Union Cabinet. The purpose of Ordinances is to allow governments to take immediate legislative action if circumstances make it necessary to do so at a time when Parliament is not in session. Often though Ordinances are used by governments to pass legislation which is currently pending in Parliament, as was the case with the Food Security Ordinance last year. Governments also take the Ordinance route to address matters of public concern as was the case with the Criminal Law (Amendment) Ordinance, 2013, which was issued in response to the protests surrounding the Delhi gang rape incident. Since the beginning of the first Lok Sabha in 1952, 637 Ordinances have been promulgated. The graph below gives a breakdown of the number of Bills passed by each Lok Sabha since 1952, as well as the number of Ordinances promulgated during each Lok Sabha. 
Ordinance Making Power of the President The President has been empowered to promulgate Ordinances based on the advice of the central government under Article 123 of the Constitution. This legislative power is available to the President only when either of the two Houses of Parliament is not in session to enact laws. Additionally, the President cannot promulgate an Ordinance unless he ‘is satisfied’ that there are circumstances that require taking ‘immediate action’. Ordinances must be approved by Parliament within six weeks of reassembling or they shall cease to operate. They also cease to operate in case resolutions disapproving the Ordinance are passed by both Houses. History of Ordinances Ordinances were incorporated into the Constitution from Section 42 and 43 of the Government of India Act, 1935, which authorised the then Governor General to promulgate Ordinances ‘if circumstances exist which render it necessary for him to take immediate action’. Interestingly, most democracies including Britain, the United States of America, Australia and Canada do not have provisions similar to that of Ordinances in the Indian Constitution. The reason for an absence of such a provision is because legislatures in these countries meet year long. Ordinances became part of the Indian Constitution after much debate and discussion. Some Members of the Constituent Assembly emphasised that the Ordinance making power of the President was extraordinary and issuing of Ordinances could be interpreted as against constitutional morality. Some Members felt that Ordinances were a hindrance to personal freedom and a relic of foreign rule. Others argued that Ordinances should be left as a provision to be used only in the case of emergencies, for example, in the breakdown of State machinery. As a safeguard, Members argued that the provision that a session of Parliament must be held within 6 months of passing an Ordinance be added. Repromulgation of Ordinances Ordinances are only temporary laws as they must be approved by Parliament within six weeks of reassembling or they shall cease to operate. However, governments have promulgated some ordinances multiple times. For example, The Securities Laws (Amendment) Ordinance, 2014 was recently repromulgated for the third time during the term of the 15th Lok Sabha. Repromulgation of Ordinances raises questions about the legislative authority of the Parliament as the highest law making body. In the 1986 Supreme Court judgment of D.C. Wadhwa vs. State of Bihar, where the court was examining a case where a state government (under the authority of the Governor) continued to re-promulgate Ordinances, the Constitution Bench headed by Chief Justice P.N. Bhagwati observed: “The power to promulgate an Ordinance is essentially a power to be used to meet an extraordinary situation and it cannot be allowed to be "perverted to serve political ends". It is contrary to all democratic norms that the Executive should have the power to make a law, but in order to meet an emergent situation, this power is conferred on the Governor and an Ordinance issued by the Governor in exercise of this power must, therefore, of necessity be limited in point of time.” 
Thanks to Vinayak Rajesekhar for helping with research on this blog post.
Recently, the Supreme Court collegium reiterated its recommendations for the appointment of 11 judges to certain High Courts. It had first recommended these names earlier this year and in August last year, but these appointments were not made. The Indian judiciary faces high vacancies across all levels (the Supreme Court, High Courts, and subordinate courts). Vacancy of judges in courts is one of the reasons for delays and a rising number of pending cases, as there are not enough judges to hear and decide cases. As of today, more than four crore cases are pending across all courts in India. In this blog post, we discuss vacancies across courts over the years, delays in appointment of judges, and methods to determine the adequate judge strength required to handle the caseload courts face.
High vacancy of judges across courts
Vacancies in courts keep on arising periodically due to retirement, resignation, demise, or elevation of judges. Over the years, the sanctioned strength of judges in both High Courts and subordinate courts has been increased gradually. However, vacancies persist due to insufficient appointments (see Figures 1 and 2). Between 2010 and 2020, vacancies increased from 18% to 21% across all levels of courts (from 6% to 12% in the Supreme Court, from 33% to 38% in High Courts, and from 18% to 20% in subordinate courts).
|
Figure 1: Vacancy of judges in High Courts |
Figure 2: Vacancy of judges in subordinate courts |
|
|
|
|
Sources: Court News 2010-2018; Vacancy Statement, and Rajya Sabha replies, Part I, Budget Session (2021), Department of Justice; PRS. |
|
As on November 1, 2021, the Supreme Court had a vacancy of one judge (out of a sanctioned strength of 34). Vacancy in High Courts stood at 37% (406 posts vacant out of a sanctioned strength of 1,098). Since May, 2021, the Supreme Court collegium has recommended more than 130 names for appointment as High Court judges. In three High Courts (Telangana, Patna, and Calcutta), at least half of the posts are vacant (see Figure 3). The Standing Committee on Personnel, Public Grievances, Law and Justice (2020) noted that every year, 35-40% of posts of High Court judges remain unfilled.
|
Figure 3: Vacancy of judges across High Courts (in %) (as on November 1, 2021)
|
|
Source: Vacancy Statement, Department of Justice; PRS. |
Appointments of High Court judges are guided by a memorandum of procedure. As per this memorandum, the appointment process is to be initiated by the concerned High Court at least six months before a vacancy occurs. However, the Standing Committee (2021) noted that this timeline is rarely adhered to by High Courts. Further, in the final stage of the process, after receiving recommendations from the Supreme Court collegium, the executive appoints judges to the High Court. No timeline is prescribed for this stage of the appointment process. In 2018 and 2019, the average time taken to appoint High Court judges after receiving the collegium’s recommendations was five to seven months.
As of today, over 3.6 crore cases are pending before subordinate courts in India. As on February 20, 2020, 21% posts for judges were vacant (5,146 posts out of the sanctioned strength of 24,018) in subordinate courts. Subordinate courts in Bihar, Haryana, and Jharkhand (among the states with high population) had a high proportion of vacancies of judges (see Figure 4). Note that the Supreme Court is monitoring the procedure for appointment of judges to subordinate courts.
For an analysis of the data on pendency and vacancies in the Indian judiciary, see here.
Figure 4: Vacancy of judges across subordinate courts (in %) (as on February 20, 2020)
|
|
|
Source: Report No. 101, Standing Committee on Personnel, Public Grievances, Law and Justice (2020); PRS. |
How many judges do we need?
The Law Commission of India (1987) had noted the importance of manpower planning for the judiciary. Lack of adequate number of judges means a greater workload per judge. Thus, it becomes essential to arrive at an optimal judge strength to deal with pending and new cases in courts. Over the years, different methods of calculating the required judge strength for subordinate courts (where the backlog of cases in the Indian judiciary is concentrated) have been recommended (see Table 1).
Table 1: Methods recommended for calculating the required number of judges for subordinate courts
|
Method of calculation |
Recommendation and its status |
|
Judge-to-population ratio: optimum number of judges per million population |
The Law Commission of India (1987) had recommended increasing this ratio to 50 judges per million people. This was reiterated by the Supreme Court (2001) and the Standing Committee on Home Affairs (2002). For 2020, the judge-to-population ratio was 21 judges per million population. Note that this figure is calculated based on the sanctioned strength of judges in the Supreme Court, High Courts and subordinate courts. |
|
Rate of disposal: number of additional judges required (to clear the existing backlog of cases and ensure that new backlog is not created) based on the average number of cases disposed per judge |
The Law Commission of India (2014) proposed this method. It rejected the judge-to-population ratio method, observing that filing of cases per capita varies substantially across geographic units depending on socio-economic conditions. |
|
Weighted case load method: calculating judge strength based on the disposal by judges, taking into account the nature and complexity of cases in local conditions |
The National Court Management Systems Committee (NCMS) (2016) critiqued the rate of disposal method. It proposed, as an interim measure, the weighted case load method, which addresses the existing backlog of cases as well as the new flow of cases every year in subordinate courts. In 2017, the Supreme Court accepted this model. |
|
Time-based weighted case load method: calculating the required judge strength taking into account the actual time spent by judges in different types of cases at varying stages based on an empirical study |
Used widely in the United States, this was the long-term method recommended by the NCMS (2016) to assess the required judge strength for subordinate courts. It involves determining the total number of ‘judicial hours’ required for disposing of the case load of each court. The Delhi High Court used this approach in a pilot project (January 2017- December 2018) to calculate the ideal judge strength for disposing of pending cases in certain courts in Delhi. |
Sources: Reports No. 120 (1987) and 245 (2014), Law Commission of India; Report No. 85, Standing Committee on Home Affairs (2002); Note for Calculating Required Judge Strength for Subordinate Courts, National Court Management Systems Committee (NCMS) (2016); Imtiyaz Ahmad vs. State of Uttar Pradesh, Supreme Court (2017); PRS.
