The ongoing Monsoon Session of Parliament is being widely viewed as the 'make or break' session for passing legislation before the end of the 15th Lok Sabha in 2014. Hanging in balance are numerous important Bills, which will lapse if not passed before the upcoming 2014 national elections. Data indicates that the current Lok Sabha has passed the least number of Bills in comparison to other comparable Lok Sabhas. The allocated time to be spent on legislation in the Monsoon Session is also below the time recommended for discussion and passing of Bills by the Business Advisory Committee of the Lok Sabha. Eight out of a total of 16 sittings of the Monsoon Session have finished with only 15 percent of the total time spent productively. Success rate of the 15th Lok Sabha in passing legislation India’s first Lok Sabha (1952-1957) passed a total of 333 Bills in its five year tenure. Since then, every Lok Sabha which has completed over three years of its full term has passed an average of 317 Bills. Where a Lok Sabha has lasted for less than 3 years, it has passed an average of 77 Bills. This includes the 6th, 9th, 11th and 12th Lok Sabhas. The ongoing 15th Lok Sabha, which is in the fifth year of its tenure, has passed only 151 Bills (This includes the two Bills passed in the Monsoon Session as of August 18, 2013). In terms of parliamentary sessions, Lok Sabhas that have lasted over three years have had an average of fifteen sessions. The 15th Lok Sabha has finished thirteen parliamentary sessions with the fourteenth (Monsoon Session) currently underway. 
Legislative business accomplished in the 15th Lok Sabha For the 15th Lok Sabha, a comparison of the government's legislative agenda at the beginning of a parliamentary session with the actual number of Bills introduced and passed at the end of the session shows that: (i) on average, government has a success rate of getting 39 percent of Bills passed; and (ii) on average, 60 percent success rate in getting Bills introduced. 
The Monsoon Session of Parliament was scheduled to have a total of 16 sitting days between August 5-30, 2013. Of the 43 Bills listed for consideration and passage, 32 are Bills pending from previous sessions. As of August 18, 2013, the Rajya Sabha had passed a total of five Bills while the Lok Sabha had passed none. Of the 25 Bills listed for introduction, ten have been introduced so far. The Budget Session of Parliament earlier this year saw the passage of only two Bills, apart from the appropriation Bills, of the 38 listed for passing. These were the Protection of Women Against Sexual Harassment at Workplace Bill and the Criminal Law (Amendment) Bill. Time allocated for legislation in the Monsoon Session The Lok Sabha is scheduled to meet for six hours and the Rajya Sabha for five hours every day. Both houses have a question hour and a zero hour at the beginning of the day, which leaves four hours for legislative business in the Lok Sabha and three hours in the Rajya Sabha. However, both Houses can decide to meet for a longer duration. For example, Rajya Sabha has decided to meet till 6:00 PM every day in the Monsoon Session as against the normal working hours of the House until 5:00 PM. The Business Advisory Committee (BAC) of both Houses recommends the time that should be allocated for discussion on each Bill. This session's legislative agenda includes a total of 43 Bills to be passed by Parliament. So far, 30 of the Bills have been allocated time by the BAC, adding up to a total of 78 hours of discussion before passing. If the Lok Sabha was to discuss and debate the 30 Bills for roughly the same time as was recommended by the BAC, it would need a minimum of 20 working days. In addition, extra working days would need to be allocated to discuss and debate the remaining 13 Bills. With eight sitting days left and not a single Bill being passed by the Lok Sabha, it is unclear how the Lok Sabha will be able to make up the time to pass Bills with thorough debate.
Recently, the Supreme Court collegium reiterated its recommendations for the appointment of 11 judges to certain High Courts. It had first recommended these names earlier this year and in August last year, but these appointments were not made. The Indian judiciary faces high vacancies across all levels (the Supreme Court, High Courts, and subordinate courts). Vacancy of judges in courts is one of the reasons for delays and a rising number of pending cases, as there are not enough judges to hear and decide cases. As of today, more than four crore cases are pending across all courts in India. In this blog post, we discuss vacancies across courts over the years, delays in appointment of judges, and methods to determine the adequate judge strength required to handle the caseload courts face.
High vacancy of judges across courts
Vacancies in courts keep on arising periodically due to retirement, resignation, demise, or elevation of judges. Over the years, the sanctioned strength of judges in both High Courts and subordinate courts has been increased gradually. However, vacancies persist due to insufficient appointments (see Figures 1 and 2). Between 2010 and 2020, vacancies increased from 18% to 21% across all levels of courts (from 6% to 12% in the Supreme Court, from 33% to 38% in High Courts, and from 18% to 20% in subordinate courts).
|
Figure 1: Vacancy of judges in High Courts |
Figure 2: Vacancy of judges in subordinate courts |
|
|
|
|
Sources: Court News 2010-2018; Vacancy Statement, and Rajya Sabha replies, Part I, Budget Session (2021), Department of Justice; PRS. |
|
As on November 1, 2021, the Supreme Court had a vacancy of one judge (out of a sanctioned strength of 34). Vacancy in High Courts stood at 37% (406 posts vacant out of a sanctioned strength of 1,098). Since May, 2021, the Supreme Court collegium has recommended more than 130 names for appointment as High Court judges. In three High Courts (Telangana, Patna, and Calcutta), at least half of the posts are vacant (see Figure 3). The Standing Committee on Personnel, Public Grievances, Law and Justice (2020) noted that every year, 35-40% of posts of High Court judges remain unfilled.
|
Figure 3: Vacancy of judges across High Courts (in %) (as on November 1, 2021)
|
|
Source: Vacancy Statement, Department of Justice; PRS. |
Appointments of High Court judges are guided by a memorandum of procedure. As per this memorandum, the appointment process is to be initiated by the concerned High Court at least six months before a vacancy occurs. However, the Standing Committee (2021) noted that this timeline is rarely adhered to by High Courts. Further, in the final stage of the process, after receiving recommendations from the Supreme Court collegium, the executive appoints judges to the High Court. No timeline is prescribed for this stage of the appointment process. In 2018 and 2019, the average time taken to appoint High Court judges after receiving the collegium’s recommendations was five to seven months.
As of today, over 3.6 crore cases are pending before subordinate courts in India. As on February 20, 2020, 21% posts for judges were vacant (5,146 posts out of the sanctioned strength of 24,018) in subordinate courts. Subordinate courts in Bihar, Haryana, and Jharkhand (among the states with high population) had a high proportion of vacancies of judges (see Figure 4). Note that the Supreme Court is monitoring the procedure for appointment of judges to subordinate courts.
For an analysis of the data on pendency and vacancies in the Indian judiciary, see here.
Figure 4: Vacancy of judges across subordinate courts (in %) (as on February 20, 2020)
|
|
|
Source: Report No. 101, Standing Committee on Personnel, Public Grievances, Law and Justice (2020); PRS. |
How many judges do we need?
The Law Commission of India (1987) had noted the importance of manpower planning for the judiciary. Lack of adequate number of judges means a greater workload per judge. Thus, it becomes essential to arrive at an optimal judge strength to deal with pending and new cases in courts. Over the years, different methods of calculating the required judge strength for subordinate courts (where the backlog of cases in the Indian judiciary is concentrated) have been recommended (see Table 1).
Table 1: Methods recommended for calculating the required number of judges for subordinate courts
|
Method of calculation |
Recommendation and its status |
|
Judge-to-population ratio: optimum number of judges per million population |
The Law Commission of India (1987) had recommended increasing this ratio to 50 judges per million people. This was reiterated by the Supreme Court (2001) and the Standing Committee on Home Affairs (2002). For 2020, the judge-to-population ratio was 21 judges per million population. Note that this figure is calculated based on the sanctioned strength of judges in the Supreme Court, High Courts and subordinate courts. |
|
Rate of disposal: number of additional judges required (to clear the existing backlog of cases and ensure that new backlog is not created) based on the average number of cases disposed per judge |
The Law Commission of India (2014) proposed this method. It rejected the judge-to-population ratio method, observing that filing of cases per capita varies substantially across geographic units depending on socio-economic conditions. |
|
Weighted case load method: calculating judge strength based on the disposal by judges, taking into account the nature and complexity of cases in local conditions |
The National Court Management Systems Committee (NCMS) (2016) critiqued the rate of disposal method. It proposed, as an interim measure, the weighted case load method, which addresses the existing backlog of cases as well as the new flow of cases every year in subordinate courts. In 2017, the Supreme Court accepted this model. |
|
Time-based weighted case load method: calculating the required judge strength taking into account the actual time spent by judges in different types of cases at varying stages based on an empirical study |
Used widely in the United States, this was the long-term method recommended by the NCMS (2016) to assess the required judge strength for subordinate courts. It involves determining the total number of ‘judicial hours’ required for disposing of the case load of each court. The Delhi High Court used this approach in a pilot project (January 2017- December 2018) to calculate the ideal judge strength for disposing of pending cases in certain courts in Delhi. |
Sources: Reports No. 120 (1987) and 245 (2014), Law Commission of India; Report No. 85, Standing Committee on Home Affairs (2002); Note for Calculating Required Judge Strength for Subordinate Courts, National Court Management Systems Committee (NCMS) (2016); Imtiyaz Ahmad vs. State of Uttar Pradesh, Supreme Court (2017); PRS.
