The Minister of Railways, Dinesh Trivedi, presented the Railways Budget 2012 to Parliament on 14th March. While commenting on the financial position of Railways, the Minister said that 'the Indian Railways are passing through a difficult phase'. The Operating Ratio for the closing year is now estimated to equal 95%. This is significantly higher than the 91.1% figure budgeted last year. Operating Ratio is a metric that compares operating expenses to revenues. A higher ratio indicates lower ability to generate surplus. Surplus is used for capital investments such as laying of new lines, deploying more coaches etc. Therefore, a smaller surplus affects the Railway’s capability to make such investments. Budget v/s Revised estimates 2011-12 Budget 2011-12 had estimated the performance of Railways for the financial year. Revised estimates have now been submitted. Taken together, these two figures help in comparing actual performance against targets. Some observations are enumerated below:
Budget estimates 2012-13 In 2012-13, Railways plan to improve Operating Ratio to 84.9% and to increase surplus to Rs 15,557 crore. This is more than 10 times the surplus generated in 2011-12 (Revised Estimates). The effective increase in freight rates is estimated to average 23%. During this time, passenger fares are also estimated to increase by an effective average rate of 19%. [1] Infrastructure Performance during the 11th Plan Under the 11th Five Year Plan, the total plan expenditure for Railways had been approved at Rs 2,33,289 crore. The Outcome Budget shows that the actual expenditure is only likely to be Rs 1,92,291 crore. Thus, expenditure will fall short by Rs 40,998 crore. This gaps exists despite a significant increase in the Gross Budgetary Support approved by Parliament. Plan expenditure during 2007-12 (In Rs Crore)
|
Approved Expenditure |
Actual Expenditure |
|
| Gross Budgetary Support |
63,635 |
75,979 |
| Internal Resources |
90,000 |
67,763 |
| Extra Budgetary Support |
79,654 |
48,549 |
| Total |
2,33,289 |
1,92,291 |
The Standing Committee on Railways, in its 11th report presented in August 2011, had sought an explanation from the Ministry. According to the Ministry, lower mobilization of internal resources and lack of extra budgetary support are the main reasons for the shortfall. Internal resource mobilization has been low because of (i) impact of the 6th Pay Commission; and (ii) slow growth in freight earnings due to the economic slowdown. Extra budgetary resources have been low due to non-materialization of funds through the Public-Private Partnership route. Proposals for the 12th Plan Two recent committees – Kakodkar Committee on Railway Safety and the Pitroda Committee on Railway Modernization – have called for large investments in the next five years. The Kakodkar Committee has recommended an investment of Rs 1,00,000 crore in the next five years to improve safety; the Pitroda Committee has recommended an expenditure of Rs 3,96,000 crore in the next five years on modernization. The Railway sub-group of the 12th Five Year Plan has also estimated a requirement of Rs 4,42,744 crore for various other investments proposed to be undertaken during the Plan period. [2] All three groups have called for significant investments in infrastructure augmentation in the next five years. Budget proposals 2012-13 According to the Minister’s speech, the Annual Plan outlay for the year 2012-13 has been set at Rs 60,100 crore. The plan would be financed through:
What happens now? The Budget is likely to be discussed in the two Houses within the next few days. Post the discussion, the Ministry's proposals will be put to vote. Once passed, the Ministry can put its proposals into action. For more details on the Railway Budget, including the projects proposed this year and the status of proposals made last year, please see our analysis here. To understand some of the challenges faced by the Indian Railways, see our blog post from last year. Notes: [1] The ‘effective average fare’ has been calculated by dividing the total income from the segment (freight/ passenger) by the total traffic (in NTKM/ PKM). This would vary with changes in fares as well as the usage by different categories of users (including the proportion of tickets booked through Tatkal). [2] Source: Report of the Expert Group on Railway Modernization (Chairman: Sam Pitroda)
Recently, the Supreme Court collegium reiterated its recommendations for the appointment of 11 judges to certain High Courts. It had first recommended these names earlier this year and in August last year, but these appointments were not made. The Indian judiciary faces high vacancies across all levels (the Supreme Court, High Courts, and subordinate courts). Vacancy of judges in courts is one of the reasons for delays and a rising number of pending cases, as there are not enough judges to hear and decide cases. As of today, more than four crore cases are pending across all courts in India. In this blog post, we discuss vacancies across courts over the years, delays in appointment of judges, and methods to determine the adequate judge strength required to handle the caseload courts face.
High vacancy of judges across courts
Vacancies in courts keep on arising periodically due to retirement, resignation, demise, or elevation of judges. Over the years, the sanctioned strength of judges in both High Courts and subordinate courts has been increased gradually. However, vacancies persist due to insufficient appointments (see Figures 1 and 2). Between 2010 and 2020, vacancies increased from 18% to 21% across all levels of courts (from 6% to 12% in the Supreme Court, from 33% to 38% in High Courts, and from 18% to 20% in subordinate courts).
|
Figure 1: Vacancy of judges in High Courts |
Figure 2: Vacancy of judges in subordinate courts |
|
|
|
|
Sources: Court News 2010-2018; Vacancy Statement, and Rajya Sabha replies, Part I, Budget Session (2021), Department of Justice; PRS. |
|
As on November 1, 2021, the Supreme Court had a vacancy of one judge (out of a sanctioned strength of 34). Vacancy in High Courts stood at 37% (406 posts vacant out of a sanctioned strength of 1,098). Since May, 2021, the Supreme Court collegium has recommended more than 130 names for appointment as High Court judges. In three High Courts (Telangana, Patna, and Calcutta), at least half of the posts are vacant (see Figure 3). The Standing Committee on Personnel, Public Grievances, Law and Justice (2020) noted that every year, 35-40% of posts of High Court judges remain unfilled.
|
Figure 3: Vacancy of judges across High Courts (in %) (as on November 1, 2021)
|
|
Source: Vacancy Statement, Department of Justice; PRS. |
Appointments of High Court judges are guided by a memorandum of procedure. As per this memorandum, the appointment process is to be initiated by the concerned High Court at least six months before a vacancy occurs. However, the Standing Committee (2021) noted that this timeline is rarely adhered to by High Courts. Further, in the final stage of the process, after receiving recommendations from the Supreme Court collegium, the executive appoints judges to the High Court. No timeline is prescribed for this stage of the appointment process. In 2018 and 2019, the average time taken to appoint High Court judges after receiving the collegium’s recommendations was five to seven months.
As of today, over 3.6 crore cases are pending before subordinate courts in India. As on February 20, 2020, 21% posts for judges were vacant (5,146 posts out of the sanctioned strength of 24,018) in subordinate courts. Subordinate courts in Bihar, Haryana, and Jharkhand (among the states with high population) had a high proportion of vacancies of judges (see Figure 4). Note that the Supreme Court is monitoring the procedure for appointment of judges to subordinate courts.
For an analysis of the data on pendency and vacancies in the Indian judiciary, see here.
Figure 4: Vacancy of judges across subordinate courts (in %) (as on February 20, 2020)
|
|
|
Source: Report No. 101, Standing Committee on Personnel, Public Grievances, Law and Justice (2020); PRS. |
How many judges do we need?
The Law Commission of India (1987) had noted the importance of manpower planning for the judiciary. Lack of adequate number of judges means a greater workload per judge. Thus, it becomes essential to arrive at an optimal judge strength to deal with pending and new cases in courts. Over the years, different methods of calculating the required judge strength for subordinate courts (where the backlog of cases in the Indian judiciary is concentrated) have been recommended (see Table 1).
Table 1: Methods recommended for calculating the required number of judges for subordinate courts
|
Method of calculation |
Recommendation and its status |
|
Judge-to-population ratio: optimum number of judges per million population |
The Law Commission of India (1987) had recommended increasing this ratio to 50 judges per million people. This was reiterated by the Supreme Court (2001) and the Standing Committee on Home Affairs (2002). For 2020, the judge-to-population ratio was 21 judges per million population. Note that this figure is calculated based on the sanctioned strength of judges in the Supreme Court, High Courts and subordinate courts. |
|
Rate of disposal: number of additional judges required (to clear the existing backlog of cases and ensure that new backlog is not created) based on the average number of cases disposed per judge |
The Law Commission of India (2014) proposed this method. It rejected the judge-to-population ratio method, observing that filing of cases per capita varies substantially across geographic units depending on socio-economic conditions. |
|
Weighted case load method: calculating judge strength based on the disposal by judges, taking into account the nature and complexity of cases in local conditions |
The National Court Management Systems Committee (NCMS) (2016) critiqued the rate of disposal method. It proposed, as an interim measure, the weighted case load method, which addresses the existing backlog of cases as well as the new flow of cases every year in subordinate courts. In 2017, the Supreme Court accepted this model. |
|
Time-based weighted case load method: calculating the required judge strength taking into account the actual time spent by judges in different types of cases at varying stages based on an empirical study |
Used widely in the United States, this was the long-term method recommended by the NCMS (2016) to assess the required judge strength for subordinate courts. It involves determining the total number of ‘judicial hours’ required for disposing of the case load of each court. The Delhi High Court used this approach in a pilot project (January 2017- December 2018) to calculate the ideal judge strength for disposing of pending cases in certain courts in Delhi. |
Sources: Reports No. 120 (1987) and 245 (2014), Law Commission of India; Report No. 85, Standing Committee on Home Affairs (2002); Note for Calculating Required Judge Strength for Subordinate Courts, National Court Management Systems Committee (NCMS) (2016); Imtiyaz Ahmad vs. State of Uttar Pradesh, Supreme Court (2017); PRS.
