By Rohit and Jhalak Some Rajya Sabha seats will be contested over the next year.  The Presidential elections are also scheduled to be held in 2012.  The recent assembly elections has implications for both these elections.  The Presidential elections will depend on the strenght in the assemblies, in Lok Sabha and in Rajya Sabha (which could change over the next year).  Implications for Rajya Sabha Elections The composition of Rajya Sabha may undergo some changes.  A total of 12 Rajya Sabha seats are up for election in 2011.  This includes 6 seats from West Bengal, 3 from Gujarat and 1 each from Maharashtra, Tamil Nadu and Goa.  Another 65 seats, across 18 states, go for elections in early 2012.  The largest chunk of these seats comes from UP(10), followed by Andhra Pradesh(6), Bihar(6) and Maharashtra(6). Since Rajya Sabha members are elected by the elected members of the Legislative Assembly of the State, a change in the composition of the assembly can affect the election outcome.  We used the current assembly compositions to work out scenarios for Rajya Sabha in 2011 and 2012.  There could be alliances between parties for the Rajya Sabha elections, so we have estimated a range for each grouping (Scenario I and II) for 2012.  See Notes [1] and [2]. 

Parties/ Coalitions 2010 Scenario 2011 Scenario 2012
      I II
UPA 89 94 95 97
NDA 65 65 67 66
Left 22 19 14 14
BSP 18 18 19 19
SP 5 5 6 6
AIADMK 4 5 5 5
BJD 6 6 5 5
Other parties 18 18 20 19
Independent 6 6 5 5
Nominated 8 9 9 9
Total 241 245 245 245

Implications for the election of the President The President is elected in accordance with the provisions of Article 54 and 55 of the Constitution.  The electorate consists of the elected members of Lok Sabha, Rajya Sabha and all Legislative Assemblies.  Each MP/ MLA's vote has a pre-determined value based on the population they represent.  The election is held in accordance with the system of proportional representation by means of a single transferable vote.  The winning candidate must secure at least 50% of the total value of votes polled. (For details, refer to this Election Commission document).  There is no change in the Lok Sabha composition (unless there are bye-elections). Position in Legislative Assemblies After the recent round of assembly elections, the all-India MLA count adds up to:

UPA 1613
NDA 1106
Left 205
BSP 246
AIADMK 155
BJD 103
SP 95
Others 597

The above numbers can now be used to estimate the value of votes polled by each coalition. See Note [3]:

Value of votes cast Scenario - 1 Scenario - 2
UPA 439,437 440,853
NDA 307,737 307,029
Left 51,646 51,646
BSP 77,243 77,243
SP 38,531 38,531
AIADMK 36,392 36,392
BJD 28,799 28,799
Others 119,097 118,389
Total 1,098,882 1,098,882
Min. to be elected 549,442 549,442

The UPA has the highest value of votes polled but the figure is not sufficient to get its candidate elected.  Assuming that there are at most three candidates with significant support (UPA, NDA, and Left/Third Front), the winner will be the one who manages to bridge the gap with second preference votes.  On this factor, the UPA backed candidate is likely to hold the edge over others.  Notes: [1] At present, there are four vacant seats in Rajya Sabha (1 Maharashtra, 1 TN, 1 WB and 1 Nominated).  It is assumed that all these seats are filled up in 2011. [2] Three of the 11 nominated members in the current Rajya Sabha have declared their party affiliation as INC.  These have been included in the UPA count in the above analysis.  For the sake of simplicity, it is assumed that members who get nominated in 2011/ 12 are not aligned to any party/ coalition. [3] The above analysis is based on the assumption that the next set of assembly elections happen after the Presidential election.

Recently, the Supreme Court collegium reiterated its recommendations for the appointment of 11 judges to certain High Courts.  It had first recommended these names earlier this year and in August last year, but these appointments were not made.  The Indian judiciary faces high vacancies across all levels (the Supreme Court, High Courts, and subordinate courts).  Vacancy of judges in courts is one of the reasons for delays and a rising number of pending cases, as there are not enough judges to hear and decide cases.  As of today, more than four crore cases are pending across all courts in India.   In this blog post, we discuss vacancies across courts over the years, delays in appointment of judges, and methods to determine the adequate judge strength required to handle the caseload courts face.

High vacancy of judges across courts

Vacancies in courts keep on arising periodically due to retirement, resignation, demise, or elevation of judges.  Over the years, the sanctioned strength of judges in both High Courts and subordinate courts has been increased gradually.  However, vacancies persist due to insufficient appointments (see Figures 1 and 2).  Between 2010 and 2020, vacancies increased from 18% to 21% across all levels of courts (from 6% to 12% in the Supreme Court, from 33% to 38% in High Courts, and from 18% to 20% in subordinate courts). 

Figure 1: Vacancy of judges in High Courts

Figure 2: Vacancy of judges in subordinate courts

image

image

Sources: Court News 2010-2018; Vacancy Statement, and Rajya Sabha replies, Part I, Budget Session (2021), Department of Justice; PRS.

As on November 1, 2021, the Supreme Court had a vacancy of one judge (out of a sanctioned strength of 34).  Vacancy in High Courts stood at 37% (406 posts vacant out of a sanctioned strength of 1,098).  Since May, 2021, the Supreme Court collegium has recommended more than 130 names for appointment as High Court judges.  In three High Courts (Telangana, Patna, and Calcutta), at least half of the posts are vacant (see Figure 3).  The Standing Committee on Personnel, Public Grievances, Law and Justice (2020) noted that every year, 35-40% of posts of High Court judges remain unfilled. 

Figure 3: Vacancy of judges across High Courts (in %) (as on November 1, 2021)

image

Source: Vacancy Statement, Department of Justice; PRS.

 

 

 

 

 

 

 

 

 

Appointments of High Court judges are guided by a memorandum of procedure.  As per this memorandum, the appointment process is to be initiated by the concerned High Court at least six months before a vacancy occurs.  However, the Standing Committee (2021) noted that this timeline is rarely adhered to by High Courts.  Further, in the final stage of the process, after receiving recommendations from the Supreme Court collegium, the executive appoints judges to the High Court.  No timeline is prescribed for this stage of the appointment process.  In 2018 and 2019, the average time taken to appoint High Court judges after receiving the collegium’s recommendations was five to seven months.

As of today, over 3.6 crore cases are pending before subordinate courts in India.  As on February 20, 2020, 21% posts for judges were vacant (5,146 posts out of the sanctioned strength of 24,018) in subordinate courts.  Subordinate courts in Bihar, Haryana, and Jharkhand (among the states with high population) had a high proportion of vacancies of judges (see Figure 4).  Note that the Supreme Court is monitoring the procedure for appointment of judges to subordinate courts.

For an analysis of the data on pendency and vacancies in the Indian judiciary, see here.

Figure 4: Vacancy of judges across subordinate courts (in %) (as on February 20, 2020)

image

Source: Report No. 101, Standing Committee on Personnel, Public Grievances, Law and Justice (2020); PRS.

 

How many judges do we need?

The Law Commission of India (1987) had noted the importance of manpower planning for the judiciary.  Lack of adequate number of judges means a greater workload per judge.  Thus, it becomes essential to arrive at an optimal judge strength to deal with pending and new cases in courts.  Over the years, different methods of calculating the required judge strength for subordinate courts (where the backlog of cases in the Indian judiciary is concentrated) have been recommended (see Table 1). 

Table 1: Methods recommended for calculating the required number of judges for subordinate courts

Method of calculation

Recommendation and its status

Judge-to-population ratio: optimum number of judges per million population

The Law Commission of India (1987) had recommended increasing this ratio to 50 judges per million people.  This was reiterated by the Supreme Court (2001) and the Standing Committee on Home Affairs (2002).  For 2020, the judge-to-population ratio was 21 judges per million population.     Note that this figure is calculated based on the sanctioned strength of judges in the Supreme Court, High Courts and subordinate courts.

Rate of disposal: number of additional judges required (to clear the existing backlog of cases and ensure that new backlog is not created) based on the average number of cases disposed per judge

The Law Commission of India (2014) proposed this method.  It rejected the judge-to-population ratio method, observing that filing of cases per capita varies substantially across geographic units depending on socio-economic conditions.

Weighted case load method: calculating judge strength based on the disposal by judges, taking into account the nature and complexity of cases in local conditions

The National Court Management Systems Committee (NCMS) (2016) critiqued the rate of disposal method.     It proposed, as an interim measure, the weighted case load method, which addresses the existing backlog of cases as well as the new flow of cases every year in subordinate courts.     In 2017, the Supreme Court accepted this model.

Time-based weighted case load method: calculating the required judge strength taking into account the actual time spent by judges in different types of cases at varying stages based on an empirical study

Used widely in the United States, this was the long-term method recommended by the NCMS (2016) to assess the required judge strength for subordinate courts.  It involves determining the total number of ‘judicial hours’ required for disposing of the case load of each court.  The Delhi High Court used this approach in a pilot project (January 2017- December 2018) to calculate the ideal judge strength for disposing of pending cases in certain courts in Delhi.

Sources: Reports No. 120 (1987) and 245 (2014), Law Commission of India; Report No. 85, Standing Committee on Home Affairs (2002); Note for Calculating Required Judge Strength for Subordinate Courts, National Court Management Systems Committee (NCMS) (2016); Imtiyaz Ahmad vs. State of Uttar Pradesh, Supreme Court (2017); PRS.