![](/images/main_logo.png)
Recently, the Supreme Court collegium reiterated its recommendations for the appointment of 11 judges to certain High Courts. It had first recommended these names earlier this year and in August last year, but these appointments were not made. The Indian judiciary faces high vacancies across all levels (the Supreme Court, High Courts, and subordinate courts). Vacancy of judges in courts is one of the reasons for delays and a rising number of pending cases, as there are not enough judges to hear and decide cases. As of today, more than four crore cases are pending across all courts in India. In this blog post, we discuss vacancies across courts over the years, delays in appointment of judges, and methods to determine the adequate judge strength required to handle the caseload courts face.
High vacancy of judges across courts
Vacancies in courts keep on arising periodically due to retirement, resignation, demise, or elevation of judges. Over the years, the sanctioned strength of judges in both High Courts and subordinate courts has been increased gradually. However, vacancies persist due to insufficient appointments (see Figures 1 and 2). Between 2010 and 2020, vacancies increased from 18% to 21% across all levels of courts (from 6% to 12% in the Supreme Court, from 33% to 38% in High Courts, and from 18% to 20% in subordinate courts).
Figure 1: Vacancy of judges in High Courts |
Figure 2: Vacancy of judges in subordinate courts |
|
|
Sources: Court News 2010-2018; Vacancy Statement, and Rajya Sabha replies, Part I, Budget Session (2021), Department of Justice; PRS. |
As on November 1, 2021, the Supreme Court had a vacancy of one judge (out of a sanctioned strength of 34). Vacancy in High Courts stood at 37% (406 posts vacant out of a sanctioned strength of 1,098). Since May, 2021, the Supreme Court collegium has recommended more than 130 names for appointment as High Court judges. In three High Courts (Telangana, Patna, and Calcutta), at least half of the posts are vacant (see Figure 3). The Standing Committee on Personnel, Public Grievances, Law and Justice (2020) noted that every year, 35-40% of posts of High Court judges remain unfilled.
Figure 3: Vacancy of judges across High Courts (in %) (as on November 1, 2021) |
Source: Vacancy Statement, Department of Justice; PRS. |
Appointments of High Court judges are guided by a memorandum of procedure. As per this memorandum, the appointment process is to be initiated by the concerned High Court at least six months before a vacancy occurs. However, the Standing Committee (2021) noted that this timeline is rarely adhered to by High Courts. Further, in the final stage of the process, after receiving recommendations from the Supreme Court collegium, the executive appoints judges to the High Court. No timeline is prescribed for this stage of the appointment process. In 2018 and 2019, the average time taken to appoint High Court judges after receiving the collegium’s recommendations was five to seven months.
As of today, over 3.6 crore cases are pending before subordinate courts in India. As on February 20, 2020, 21% posts for judges were vacant (5,146 posts out of the sanctioned strength of 24,018) in subordinate courts. Subordinate courts in Bihar, Haryana, and Jharkhand (among the states with high population) had a high proportion of vacancies of judges (see Figure 4). Note that the Supreme Court is monitoring the procedure for appointment of judges to subordinate courts.
For an analysis of the data on pendency and vacancies in the Indian judiciary, see here.
Figure 4: Vacancy of judges across subordinate courts (in %) (as on February 20, 2020)
|
Source: Report No. 101, Standing Committee on Personnel, Public Grievances, Law and Justice (2020); PRS. |
How many judges do we need?
The Law Commission of India (1987) had noted the importance of manpower planning for the judiciary. Lack of adequate number of judges means a greater workload per judge. Thus, it becomes essential to arrive at an optimal judge strength to deal with pending and new cases in courts. Over the years, different methods of calculating the required judge strength for subordinate courts (where the backlog of cases in the Indian judiciary is concentrated) have been recommended (see Table 1).
Table 1: Methods recommended for calculating the required number of judges for subordinate courts
Method of calculation |
Recommendation and its status |
Judge-to-population ratio: optimum number of judges per million population |
The Law Commission of India (1987) had recommended increasing this ratio to 50 judges per million people. This was reiterated by the Supreme Court (2001) and the Standing Committee on Home Affairs (2002). For 2020, the judge-to-population ratio was 21 judges per million population. Note that this figure is calculated based on the sanctioned strength of judges in the Supreme Court, High Courts and subordinate courts. |
Rate of disposal: number of additional judges required (to clear the existing backlog of cases and ensure that new backlog is not created) based on the average number of cases disposed per judge |
The Law Commission of India (2014) proposed this method. It rejected the judge-to-population ratio method, observing that filing of cases per capita varies substantially across geographic units depending on socio-economic conditions. |
Weighted case load method: calculating judge strength based on the disposal by judges, taking into account the nature and complexity of cases in local conditions |
The National Court Management Systems Committee (NCMS) (2016) critiqued the rate of disposal method. It proposed, as an interim measure, the weighted case load method, which addresses the existing backlog of cases as well as the new flow of cases every year in subordinate courts. In 2017, the Supreme Court accepted this model. |
Time-based weighted case load method: calculating the required judge strength taking into account the actual time spent by judges in different types of cases at varying stages based on an empirical study |
Used widely in the United States, this was the long-term method recommended by the NCMS (2016) to assess the required judge strength for subordinate courts. It involves determining the total number of ‘judicial hours’ required for disposing of the case load of each court. The Delhi High Court used this approach in a pilot project (January 2017- December 2018) to calculate the ideal judge strength for disposing of pending cases in certain courts in Delhi. |
Sources: Reports No. 120 (1987) and 245 (2014), Law Commission of India; Report No. 85, Standing Committee on Home Affairs (2002); Note for Calculating Required Judge Strength for Subordinate Courts, National Court Management Systems Committee (NCMS) (2016); Imtiyaz Ahmad vs. State of Uttar Pradesh, Supreme Court (2017); PRS.
We wrote a piece for ibnlive.com on the major differences between the government’s Lok Pal Bill, 2011 and the Jan Lok Pal Bill drafted by Anna Hazare’s group. The note is reproduced below. The streets are witnessing a demand that the government’s Lok Pal Bill be replaced by the Jan Lok Pal Bill (JLP) as drafted by the team led by Anna Hazare. There are several significant differences between the two bills. In this note, we describe the some of these differences. (See here for more on the Lok Pal Bill). First, there is a divergence on the jurisdiction of the Lok Pal. Both bills include ministers, MPs for any action outside Parliament, and Group A officers (and equivalent) of the government. The government bill includes the prime minister after he demits office whereas the JLP includes a sitting prime minister. The JLP includes any act of an MP in respect of a speech or vote in Parliament (which is now protected by Article 105 of the Constitution). The JLP includes judges; the government bill excludes them. The JLP includes all government officials, while the government bill does not include junior (below Group A) officials. The government bill also includes officers of NGOs who receive government funds or any funds from the public; JLP does not cover NGOs. Second, the two Bills differ on the composition. The government bill has a chairperson and upto 8 members; at least half the members must have a judicial background. The JLP has a chairperson and 10 members, of which 4 have a judicial background. Third, the process of selecting the Lok Pal members is different. The JLP has a two stage process. A search committee will shortlist potential candidates. The search committee will have 10 members; five of these would have retired as Chief Justice of India, Chief Election Commissioner or Comptroller and Auditor General; they will select the other five from civil society. The Lok Pal chairperson and members will be selected from this shortlist by a selection committee. The selection committee consists of the prime minister, the leader of opposition in Lok Sabha, two supreme court judges, two high court chief justices, the chief election commissioner, the comptroller and auditor general, and all previous Lok Pal chairpersons. The government bill has a simpler process. The selection will be made by a committee consisting of the prime minister, the leaders of opposition in both Houses of Parliament, a supreme court judge, a high court chief justice, an eminent jurist, and an eminent person in public life. The selection committee may, at its discretion, appoint a search committee to shortlist candidates. Fourth, there are some differences in the qualifications of a member of the Lok Pal. The JLP requires a judicial member to have held judicial office for 10 years or been a high court or supreme court advocate for 15 years. The government bill requires the judicial member to be a supreme court judge or a high court chief justice. For other members, the government bill requires at least 25 years experience in anti-corruption policy, public administration, vigilance or finance. The JLP has a lower age limit of 45 years, and disqualifies anyone who has been in government service in the previous two years. Fifth, the process for removal of Lok Pal members is different. The government bill permits the president to make a reference to the Supreme Court for an inquiry, followed by removal if the member is found to be biased or corrupt. The reference may be made by the president (a) on his own, (a) on a petition signed by 100 MPs, or (c) on a petition by a citizen if the President is then satisfied that it should be referred. The President may also remove any member for insolvency, infirmity of mind or body, or engaging in paid employment. The JLP has a different process. The process starts with a complaint by any person to the Supreme Court. If the court finds misbehaviour, infirmity of mind or body, insolvency or paid employment, it may recommend his removal to the President. Sixth, the offences covered by the Bills vary. The government bill deals only with offences under the Prevention of Corruption Act. The JLP, in addition, includes offences by public servants under the Indian Penal Code, victimization of whistleblowers and repeated violation of citizen’s charter. Seventh, the government bill provides for an investigation wing under the Lok Pal. The JLP states that the CBI will be under the Lok Pal while investigating corruption cases. Eighth, the government bill provides for a prosecution wing of the Lok Pal. In the JLP, the CBI’s prosecution wing will conduct this function. Ninth, the process for prosecution is different. In the government bill, the Lok Pal may initiate prosecution in a special court. A copy of the report is to be sent to the competent authority. No prior sanction is required. In the JLP, prosecution of the prime minister, ministers, MPs and judges of supreme court and high courts may be initiated only with the permission of a 7-judge bench of the Lok Pal. Tenth, the JLP deals with grievance redressal of citizens, in addition to the process for prosecuting corruption cases. It requires every public authority to publish citizen’s charters listing its commitments to citizens. The government bill does not deal with grievance redressal. Given the widespread media coverage and public discussions, it is important that citizens understand the differences and nuances. This may be a good opportunity to enact a law which includes the better provisions of each of these two bills.