Recently, the Supreme Court collegium reiterated its recommendations for the appointment of 11 judges to certain High Courts. It had first recommended these names earlier this year and in August last year, but these appointments were not made. The Indian judiciary faces high vacancies across all levels (the Supreme Court, High Courts, and subordinate courts). Vacancy of judges in courts is one of the reasons for delays and a rising number of pending cases, as there are not enough judges to hear and decide cases. As of today, more than four crore cases are pending across all courts in India. In this blog post, we discuss vacancies across courts over the years, delays in appointment of judges, and methods to determine the adequate judge strength required to handle the caseload courts face.
High vacancy of judges across courts
Vacancies in courts keep on arising periodically due to retirement, resignation, demise, or elevation of judges. Over the years, the sanctioned strength of judges in both High Courts and subordinate courts has been increased gradually. However, vacancies persist due to insufficient appointments (see Figures 1 and 2). Between 2010 and 2020, vacancies increased from 18% to 21% across all levels of courts (from 6% to 12% in the Supreme Court, from 33% to 38% in High Courts, and from 18% to 20% in subordinate courts).
|
Figure 1: Vacancy of judges in High Courts |
Figure 2: Vacancy of judges in subordinate courts |
|
|
|
|
Sources: Court News 2010-2018; Vacancy Statement, and Rajya Sabha replies, Part I, Budget Session (2021), Department of Justice; PRS. |
|
As on November 1, 2021, the Supreme Court had a vacancy of one judge (out of a sanctioned strength of 34). Vacancy in High Courts stood at 37% (406 posts vacant out of a sanctioned strength of 1,098). Since May, 2021, the Supreme Court collegium has recommended more than 130 names for appointment as High Court judges. In three High Courts (Telangana, Patna, and Calcutta), at least half of the posts are vacant (see Figure 3). The Standing Committee on Personnel, Public Grievances, Law and Justice (2020) noted that every year, 35-40% of posts of High Court judges remain unfilled.
|
Figure 3: Vacancy of judges across High Courts (in %) (as on November 1, 2021)
|
|
Source: Vacancy Statement, Department of Justice; PRS. |
Appointments of High Court judges are guided by a memorandum of procedure. As per this memorandum, the appointment process is to be initiated by the concerned High Court at least six months before a vacancy occurs. However, the Standing Committee (2021) noted that this timeline is rarely adhered to by High Courts. Further, in the final stage of the process, after receiving recommendations from the Supreme Court collegium, the executive appoints judges to the High Court. No timeline is prescribed for this stage of the appointment process. In 2018 and 2019, the average time taken to appoint High Court judges after receiving the collegium’s recommendations was five to seven months.
As of today, over 3.6 crore cases are pending before subordinate courts in India. As on February 20, 2020, 21% posts for judges were vacant (5,146 posts out of the sanctioned strength of 24,018) in subordinate courts. Subordinate courts in Bihar, Haryana, and Jharkhand (among the states with high population) had a high proportion of vacancies of judges (see Figure 4). Note that the Supreme Court is monitoring the procedure for appointment of judges to subordinate courts.
For an analysis of the data on pendency and vacancies in the Indian judiciary, see here.
Figure 4: Vacancy of judges across subordinate courts (in %) (as on February 20, 2020)
|
|
|
Source: Report No. 101, Standing Committee on Personnel, Public Grievances, Law and Justice (2020); PRS. |
How many judges do we need?
The Law Commission of India (1987) had noted the importance of manpower planning for the judiciary. Lack of adequate number of judges means a greater workload per judge. Thus, it becomes essential to arrive at an optimal judge strength to deal with pending and new cases in courts. Over the years, different methods of calculating the required judge strength for subordinate courts (where the backlog of cases in the Indian judiciary is concentrated) have been recommended (see Table 1).
Table 1: Methods recommended for calculating the required number of judges for subordinate courts
|
Method of calculation |
Recommendation and its status |
|
Judge-to-population ratio: optimum number of judges per million population |
The Law Commission of India (1987) had recommended increasing this ratio to 50 judges per million people. This was reiterated by the Supreme Court (2001) and the Standing Committee on Home Affairs (2002). For 2020, the judge-to-population ratio was 21 judges per million population. Note that this figure is calculated based on the sanctioned strength of judges in the Supreme Court, High Courts and subordinate courts. |
|
Rate of disposal: number of additional judges required (to clear the existing backlog of cases and ensure that new backlog is not created) based on the average number of cases disposed per judge |
The Law Commission of India (2014) proposed this method. It rejected the judge-to-population ratio method, observing that filing of cases per capita varies substantially across geographic units depending on socio-economic conditions. |
|
Weighted case load method: calculating judge strength based on the disposal by judges, taking into account the nature and complexity of cases in local conditions |
The National Court Management Systems Committee (NCMS) (2016) critiqued the rate of disposal method. It proposed, as an interim measure, the weighted case load method, which addresses the existing backlog of cases as well as the new flow of cases every year in subordinate courts. In 2017, the Supreme Court accepted this model. |
|
Time-based weighted case load method: calculating the required judge strength taking into account the actual time spent by judges in different types of cases at varying stages based on an empirical study |
Used widely in the United States, this was the long-term method recommended by the NCMS (2016) to assess the required judge strength for subordinate courts. It involves determining the total number of ‘judicial hours’ required for disposing of the case load of each court. The Delhi High Court used this approach in a pilot project (January 2017- December 2018) to calculate the ideal judge strength for disposing of pending cases in certain courts in Delhi. |
Sources: Reports No. 120 (1987) and 245 (2014), Law Commission of India; Report No. 85, Standing Committee on Home Affairs (2002); Note for Calculating Required Judge Strength for Subordinate Courts, National Court Management Systems Committee (NCMS) (2016); Imtiyaz Ahmad vs. State of Uttar Pradesh, Supreme Court (2017); PRS.
Discussion on the first no-confidence motion of the 17th Lok Sabha began today. No-confidence motions and confidence motions are trust votes, used to test or demonstrate the support of Lok Sabha for the government in power. Article 75(3) of the Constitution states that the government is collectively responsible to Lok Sabha. This means that the government must always enjoy the support of a majority of the members of Lok Sabha. Trust votes are used to examine this support. The government resigns if a majority of members support a no-confidence motion, or reject a confidence motion.
So far, 28 no-confidence motions (including the one being discussed today) and 11 confidence motions have been discussed. Over the years, the number of such motions has reduced. The mid-1960s and mid-1970s saw more no-confidence motions, whereas the 1990s saw more confidence motions.
Figure 1: Trust votes in Parliament
Note: *Term shorter than 5 years; **6-year term.
Source: Statistical Handbook 2021, Ministry of Parliamentary Affairs; PRS.
The no-confidence motion being discussed today was moved on July 26, 2023. A motion of no-confidence is moved with the support of at least 50 members. The Speaker has the discretion to allot time for discussion of the motion. The Rules of Procedure state that the motion must be discussed within 10 days of being introduced. This year, the no-confidence motion was discussed 13 calendar days after introduction. Since the introduction of the no-confidence motion on July 26, 12 Bills have been introduced and 18 Bills have been passed by Lok Sabha. In the past, on four occasions, the discussion on no-confidence motions began seven days after their introduction. On these occasions, Bills and other important issues were debated before the discussion on the no-confidence motion began.
Figure 2: Members rise in support of the motion of no-confidence in Lok Sabha
Source: Sansad TV, Lok Sabha, July 26, 2023; PRS.
Figure 3: Number of days from introduction to discussion on no-confidence motions
Note: Number of days implies calendar days.
Source: Statistical Handbook 2021, Ministry of Parliamentary Affairs; PRS.
On average, no-confidence motions (excluding the one being discussed today) have been discussed for 13 hours over three days. Discussions have lasted longer than 20 hours on four instances, most recently in 2003. Today’s no-confidence motion was allotted 12 hours discussion time by the Business Advisory Committee.
Following the discussion, the motion is put to vote. 26 out of 27 no-confidence motions (excluding the one being discussed today) have been voted upon and rejected. This means that no government has ever had to resign following a vote of no-confidence. On one occasion, in 1979, the discussion on a no-confidence motion against the Morarji Desai government remained inconclusive. He resigned before the motion was put to vote. 50% of all no-confidence motions (14 out of 28) were discussed between 1965 and 1975. Of these, 12 were against governments headed by Indira Gandhi.
Figure 4: Duration of discussion on no-confidence motions
Note: This graph excludes the no confidence motion moved on July 26, 2023.
Source: Statistical Handbook 2021, Ministry of Parliamentary Affairs; PRS.
In comparison, confidence motions have a more varied history. The first motion, brought in 1979 to demonstrate confidence in Charan Singh’s government, was not discussed at all. The Prime Minister resigned before the discussion could take place. Since then, 11 confidence motions have been discussed in Lok Sabha, with nine occurring in the 1990s. During this period, several coalition governments were formed, and Prime Ministers sought to prove their majority through confidence motions. These motions have been discussed, on average, for 12 hours over two days.
Figure 5: Duration of discussion of confidence motions
Source: Statistical Handbook 2021, Ministry of Parliamentary Affairs; PRS.
Of the 11 confidence motions discussed in Lok Sabha, seven were accepted. On three instances, governments had to resign as they could not prove that they had the support of the majority. On one instance in 1996, the motion was not put to vote. Following an eleven-hour discussion on this confidence motion, Prime Minister Atal Bihari Vajpayee announced his intention to resign on the floor of the House. He resigned 16 days into his term.
Vajpayee became Prime Minister again in 1999, and faced another confidence motion. This time, it was put to vote. The motion was defeated by a margin of one vote. This has been the closest result on a trust vote in the history of Lok Sabha. The next closest result was when a motion of no-confidence against P V Narasimha Rao’s government was defeated by 14 votes in 1993. In most cases, results have been in favour of the government by a large margin.
