Recently, there have been reports of price crashes and distress sales in case of farm produce, such as tomatoesmangoes, and garlic.  In some cases, farmers have dumped their produce on roads.  Produce such as fruits and vegetables are perishable and therefore have a short shelf life.  Further, due to inadequate storage facilities and poor food processing infrastructure farmers have limited options but to sell the produce at prevailing market prices.  This can lead to distress sales or roadside discards (in some cases to avoid additional cost of transportation).

Food processing allows raw food to be stored, marketed, or preserved for consumption later.  For instance, raw agricultural produce such as fruits may be processed into juices, jams, and pickles.  Activities such as waxing (for preservation), packaging, labelling, or ripening of produce also form part of the food processing industry.

Between 2001-02 and 2016-17, production of food grains grew annually at 1.7% on average.  Production of horticulture crops surpassed food grains with an average growth rate of 4.8%.  While production has been increasing over the years, surplus produce tends to go waste at various stages such as procurement, storage, and processing due to lack of infrastructure such as cold storages and food processing units.

Source: Horticulture Statistics at a Glance 2017, Union Budget 2018-19; PRS.

Source: Horticulture Statistics at a Glance 2017, Union Budget 2018-19; PRS.

Losses high among perishables such as fruits and vegetables

Crop losses ranged between 7-16% among fruits and around 5% among cereals in 2015.  The highest losses were witnessed in case of guava, followed by mango, which are perishable fruits.  Perishables such as fruits and vegetables are more prone to losses as compared to cereals.  Such crop losses can occur during operations such as harvesting, thrashing, grading, drying, packaging, transportation, and storage depending upon the commodity.

It was estimated that the annual value of harvest and post-harvest losses of major agricultural products at the national level was Rs 92,651 crore in 2015.  The Standing Committee on Agriculture (2017) stated that such wastage can be reduced with adequate food processing facilities.

Sources: Annual Report 2016-17, Ministry of Food Processing Industries; PRS.

Sources: Annual Report 2016-17, Ministry of Food Processing Industries; PRS.

Inadequate food processing infrastructure

As previously discussed, perishables such as fruits and vegetables are more prone to damages as compared to cereals.  Due to inadequate processing facilities in close proximity, farmers may be unable to hold their produce for a long time.  Hence, they may be forced to sell their produce soon after harvest, irrespective of the prevailing market situations.  Expert committees have recommended that agri-logistics such as cold chain infrastructure and market linkages should be strengthened.

Cold chain infrastructure: Cold chain infrastructure includes processing units, cold storages, and refrigerated vans.  As of 2014, out of a required cold storage capacity of 35 million metric tonnes (MT), almost 90% (31.8 million MT) of the capacity was available (see Table 1).  However, cold storage needs to be coupled with logistical support to facilitate smooth transfer of harvested value from farms to distant locations.  This includes: (i) pack-houses for packaging and preparing fresh produce for long distance transport, (ii) refrigerated transport such as reefer vehicles, and (iii) ripening chambers to ripen raw produce before marketing.  For instance, bananas which are harvested raw may be ripened in these chambers before being marketed.

While there are sufficient cold storages, there are wide gaps in the availability of other associated infrastructure.  This implies that even though almost 90% (32 million tonnes) of cold storage capacity is available, only 15% of the required refrigerated transport exists.  Further, the shortfall in the availability of infrastructure necessary for safe handling of farm produce, like pack-houses and ripening chambers, is over 90%.

Table 1:  Gaps in cold chain infrastructure (2014)

Facility Required Available Gap % gap
Cold storage
(in million MT)

35.1

31.8 3.2

9.3%

Pack-houses

70,080

249 69,831

99.6%

Reefer vehicles

61,826

9,000 52,826

85.4%

Ripening chambers

9,131

812 8,319

91.1%

Source: Standing Committee on Agriculture 2018; PRS.

To minimise post-harvest losses, the Standing Committee (2017) recommended that a country-wide integrated cold chain infrastructure network at block and district levels should be created.  It further recommended that a Cold Chain Coordination and Monitoring Committee should be constituted at the district-level.  The Standing Committee also recommended that farmers need to be trained in value addition activities such as sorting, grading, and pre-cooling harvested produce through facilities such as freezers and ripening chambers.

Between 2008 and 2017, 238 cold chain projects were sanctioned under the Scheme for Integrated Cold Chain and Value Addition Infrastructure.  Grants worth Rs 1,775 crore were approved for these projects.  Of this amount, Rs 964 crore (54%) has been released as of January 2018.  Consequently, out of the total projects sanctioned, 114 (48%) are completed.  The remaining 124 projects are currently under implementation.

Transport Facilities:  Currently, majority of food grains and certain quantities of tea, potato, and onion are transported through railways.  The Committee on Doubling Farmers Income had recommended that railways needs to upgrade its logistics to facilitate the transport of fresh produce directly to export hubs.  This includes creation of adjoining facilities for loading and unloading, and distribution to road transport.

Mega Food Parks: The Mega Food Parks scheme was launched in 2008.  It seeks to facilitate setting up of food processing units.  These units are to be located at a central processing centre with infrastructure required for processing, packaging, quality control labs, and trade facilitation centres.

As of March 2018, out of the 42 projects approved, 10 were operational.  The Standing Committee on Agriculture noted certain reasons for delay in implementation of projects under the scheme.  These include: (i) difficulty in getting loans from banks for the project, (ii) delay in obtaining clearances from the state governments and agencies for roads, power, and water at the project site, (iii) lack of special incentives for setting up food processing units in Mega Food Parks, and (iv) unwillingness of the co-promoters in contributing their share of equity.

Further, the Standing Committee stated that as the scheme requires a minimum area of 50 acres, it does not to promote smaller or individual food processing and preservation units.  It recommended that smaller agro-processing clusters near production areas must be promoted.  The Committee on Doubling Farmers Income recommended establishment of processing and value addition units at strategic places.  This includes rural or production areas for pulses, millets, fruits, vegetables, dairy, fisheries, and poultry in public private-partnership mode.

Yesterday, the BJP announced its candidate for the upcoming election of the President, which is scheduled to be held on July 17.  In light of this, we take a look at the manner in which the election to the office of the President is conducted, given his role and relevance in the Constitutional framework.

In his report to the Constituent Assembly, Jawaharlal Nehru had explained, “we did not want to make the President a mere figurehead like the French President.  We did not give him any real power but we have made his position one of great authority and dignity.”  His comment sums up the role of the President as intended by our Constitution framers.  The Constituent Assembly was clear to emphasise that real executive power would be exercised by the government elected directly by citizens.  It is for this reason that, in performing his duties, the President functions on the aid and advise of the government.

However, it is also the President who is regarded as the Head of the State, and takes the oath to ‘protect and defend the Constitution and law’ (Article 60 of the Constitution).  In order to elect a figure head who would embody the higher ideals and values of the Constitution, the Constituent Assembly decided upon an indirect method for the election of the President.

The President is elected by an Electoral College.  While deciding on who would make up the electoral college, the Constituent Assembly had debated several ideas.  Dr. B.R Ambedkar noted that the powers of the President extend both to the administration of the centre as well as to that of the states.  Hence, in the election of the President, not only should Members of Parliament (MPs) play a part, but Members of the state legislative assemblies (MLAs) should also have a voice.  Further, in relation to the centre, some members suggested that the college should comprise only members of the Lok Sabha since they are directly elected by the people.  However, others argued that members of Rajya Sabha must be included as well since they are elected by members of directly elected state assemblies.  Consequently, the Electoral College comprises all 776 MPs from both houses, and 4120 MLAs from all states.  Note that MLCs of states with legislative councils are not part of the Electoral College.

Another aspect that was discussed by the Constituent Assembly was that of the balance of representation between the centre and the states in the Electoral College.  The questions of how the votes of MPs and MLAs should be regarded, and if there should be a consideration of weightage of votes were raised.  Eventually, it was decided that a ‘system of Proportional Representation’ would be adopted, and voting would be conducted according to the ‘single transferable vote system’.

Under the system of proportional representation, the total weightage of all MLA votes equals the total value of that of the MPs.  However, the weightage of the votes of the MLAs varies on the basis of the population of their respective states.  For example, the vote of an MLA from Uttar Pradesh would be given higher weightage than the vote of an MLA from a less populous state like Sikkim.

Under the single transferable vote system, every voter has one vote and can mark preferences against contesting candidates.  To win the election, candidates need to secure a certain quota of votes.  A detailed explanation of how this system plays out is captured in the infographic below.

IG

Sources: Constitution of India; ECI Handbook; PRS.

Coming to the Presidential election to be held next month, the quota of votes required to be secured by the winning candidate is 5,49,452 votes.  The distribution of the vote-share of various political parties as per their strength in Parliament and state assemblies looks like this:

 

 

  • As shown in the infographic, the NDA and its allies approximately have 48% of the vote share.
  • This includes parties like the BJP, Telugu Desam Party (TDP), Shiv Sena, Shiromani Akali Dal, among others.

 

Note that the last date for filing nominations is June 28th.  In the next few days, political parties will be working across party lines to build consensus and secure the required votes for their projected candidates.

[The infographic on the process of elections was created by Jagriti Arora, currently an Intern at PRS.]